User manual LG V-C716HCB

[. . . ] Close attention is necessary when used by or near children. Do not use the vacuum cleaner if the power cord or plug is damaged or faulty. If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent to avoid a hazard. Do not handle plug or vacuum cleaner with wet hands. [. . . ] Do not continue to vacuum if any parts appear missing or damaged. Improper repairs may lead to serious hazards for the user. Do not use an extension cord with this vacuum cleaner Do not plug in if control knob is not in OFF position. Using improper voltage may result in damage to the motor and possible injury to the user. Proper voltage is listed onthe bottom of vacuum cleaner. Keep children away and beware of obstructions when rewinding the cord to prevent personal injury. Turn off all controls before unplugging. Do not use it if it is damaged, cut or punctured. Failure to do so could result in death, or electrical shock. If plug does not fit, contact a qualified electrician to install the proper outlet. Do not use with any opening blocked: keep free of dust, lint, hair, and anything that may reduce air flow. Push the end of the head(1) on the flexible hose(2) into the attachment point on the vacuum cleaner. To remove the flexible hose from the vacuum cleaner, press on the button(3) situated on the head, then pull upwards. If your appliance is equipped with an electronic variable power control(13), you can choose the power appropriated for the task. (depending on model) · The flexible hose handle(14) has a manual air flow regulator(15) which allows you to briefly reduce the suction level. When you have switched off and unplugged the appliance, press on the button (12) to automatically rewind the cord. You can move or store your appliance in a vertical position by sliding the hook on the large cleaning head into the clip on the underside of the appliance. Metal tube(4) - Fit together the two tubes by twisting slightly. The dustbag needs changing when the cleaner is set to maximum power and the cleaner head is off the floor but the "bag full" indicator window(17) is completely coloured red. Even if the dustbag does not appear to be full at this stage, it should be changed. It could be that a great deal of very fine dust has clogged up the pores of the dust bag. Open the cover by pressing the hook(18) and lifting it up until it snaps into place. [. . . ] To refit a new bag push the cardboard support of a new bag into the bag mount (20)until it will go no further. Using the cleaning head and Accessory Nozzles (depending on model) Fit the large cleaning head onto the end of the tube. ⷠThe 2 position head(7) is equipped with a pedal or two pedals(8) which allows you to alter its position according to the type of floor to be cleaned. Crevice Tool(9) For vacuuming in those normally inaccessible places i. [. . . ]