User manual LG V-CP643ND

[. . . ] Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions. Do not use the vacuum cleaner without a dust bin. [. . . ] Slide to the Stop(or Min)position before inserting a plug into the electrical outlet. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the cleaner parts. Do not block the suction or the exhaust port. Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord. Turbine Brush Remove waste For picking up pet hair and fibre matter completely Turn the lock button to `UNLOCK', when inlet is blocked. on upholstery and bed linen. Brush for blanket Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging. To reassemble, align the cover to the front of the main body and close. After closing the cover, ensure that the lock button is turned to the `LOCK' position. 4 3 EMPTYING THE DUST BIN 1 2 Once dust reaches the dust full mark, or sution is noticeably reduced during cleaning, empty Take the dust bin out by pressing the button. 4 5 6 3 Separate the dust bin cover. Throw away dust into the bin. Close the dust bin cover. - Empty into a plastic bag (recommended for asthma/allergy sufferers) Before use, push the dust bin into the main body of the vacuum cleaner until you hear the "click" sound. NOTE You may rinse the dust bin with cold water. 5 DUST PACK 4 CLEANING THETHE DUST PACK 4-1. WHEN TO CLEAN - If suction is noticeably reduced during cleaning, please check the dust pack as indicated below. Turn the vacuum power to 'MAX' HANDLE CONTROL If suction is noticeably reduced with the inlet floating 10cm above flat floor, clean it. NOTE When suction is noticeably reduced continuously, please empty the Dust Pack(4-2) as shown in the following illustration. 6 4-2 CLEANING THE DUST PACK 1 2 Remove the dust bin and dust pack as shown. 3 4 Remove the sponge and filter from the dust pack Wash the sponge and the filter of the dust pack with water. 5 6 Let the sponge and filter dry in the shade for more than 12 hours. Put the sponge and filter into the dust pack. Put the assembled dust pack into the main body. NOTE : Make sure the filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry. 7 5 CLEANING THE MOTOR PROTECTION FILTER Take out both the dust bin and the dust pack. [. . . ] Remove the motor protection filter from the vacuum cleaner. Shake and tap the dust from it and put back in machine. 6 CLEANING THE OUTLET FILTER OPTION - MICRO FILTER Press the fixed frame part at the back of the main body to remove. OPTION Remove and replace the blocked outlet filter. NOTE : Replacement filters are available at your local Samsung distributor. 8 - IF YOU HAVE A PROBLEM PROBLEM Motor does not start. [. . . ]