User manual LG V-CQ783STU

[. . . ] I Do not use the appliance If the mains lead is damaged or faulty. I If the mains lead is damaged, it must be replaced by an approved LG Electronics Service Agent in order to avoid a hazard. I Always switch the vaccum cleaner off before : · changing the dust bag · changing or cleaning the filters. [. . . ] I Always switch the vaccum cleaner off before : · changing the dust bag · changing or cleaning the filters. I If no dustbag is inserted, the cover cannot be closed. I Do not vacuum flammable or explosive substances (liquids or gases). I When you vacuum with an attachment appliance that has a rotating brush roller: · do not reach into the running brush roller. Should it become necessary to replace the moulded on plug then the detective plug should be destroyed to avoid any possible shock hazard that could occur should such a plug be inserted into a 13 amp socket else where in the house. Assembling the tubes (depending on model) · Metal tube (4, 5) - Fit together the two tubes by twisting slightly. · Telescopic tube (6) - Push spring latch (7). - Release spring latch to lock. Using the cleaning head and Accessory Nozzles (depending on model) Fit the large cleaning head onto the end of the tube. · The 2 position head (10) is equipped with a pedal (11) which allows you to alter its position according to the type of floor to be cleaned. To remove the flexible hose from the vacuum cleaner, press on the button (3) situated on the head, then pull upwards. -4- E Adjusting the power level (depending on model) · Suction capacity increases steplessly up to MAX. (19) · The flexible hose handle (20) has a manual air flow regulator (21) which allows you to briefly reduce the suction level. Cleaning the motor filter The motor filter is situated inside the appliance between the dust bag and the motor. Each time that you change the air outlet filter we advise you to remove the motor filter (29) and to clean it by tapping to remover the dirt and then replacing it in the vacuum cleaner. Carrying and storage When you have switched off and unplugged the appliance, press on the button (18) to automatically rewind the cord. · Use stowage clip as shown when storing the cleaner (22). What to do if your appliance does not work Check that the appliance is correctly plugged in and that the electrical socket is working. Changing the dust bag The dustbag needs changing when the cleaner is set to maximum power and the cleaner head is off the floor but the "bag full" indicator window (23) is completely coloured red. Even if the dustbag does not appear to be full at this stage, it should be changed. It could be that a great deal of very fine dust has clogged up the pores of the dust bag. · Turn off the appliance and unplug it. · Open the cover (24) Your appliance is equipped with either a paper dust bag or a fabric dust bag (28) (depending on model) · Push the lever forwards in the direction of the arrow (26), and pull off the full paper filter bag towards the rear. [. . . ] It could be that a great deal of very fine dust has clogged up the pores of the dust bag. · Turn off the appliance and unplug it. · Open the cover (24) Your appliance is equipped with either a paper dust bag or a fabric dust bag (28) (depending on model) · Push the lever forwards in the direction of the arrow (26), and pull off the full paper filter bag towards the rear. [. . . ]