User manual LG V-K8730HTXR

[. . . ] This information contains important instructions for the safe use and maintenance of the vacuum cleaner. Especially, please read all of the information on page 4, 5, 6 for your safety. Please keep this manual in an easily accessible place and refer to it anytime. What to do if your vacuum cleaner does not work . [. . . ] To remove the flexible hose from the vacuum cleaner, press the button situated on the fitting pipe, then pull the fitting pipe out of the vacuum cleaner. Dusting Brush is for vacuuming picture frames, furniture frames, books and other irregular surfaces. Crevice Tool is for vacuuming in those normally hard-to-reach places such as reaching cobwebs, or between the cushions of a sofa. You must use accessory nozzles in MIN mode. The 2 position cleaning head equipped with a pedal which allows you to alter its position according to the type of floor to be cleaned. You can perform cleaning at any place like corner or crevice since revolution of the suction hole is free. Remove dusts accumulated where the floor surface of the suction hole for device protection is dirty. Cleaning of the whole suction hole with water may cause failure of product performance. How to use Operating vacuum cleaner äÍ ÔÓθÁÓ, Ú¸Òfl ùÍÒÔÎÛÚ^Ëfl Ô°ÎÂÒÓÒ The indicator light of the hose handle is on and alarm will sound when dust tank is full. After about 2 minutes, vacuum cleaner will turn itself off and alarm will sound. To store during vacuuming, for example to move a small piece of furniture or a rug, use park mode to support the flexible hose and nozzle. When you have switched off and unplugged the vacuum cleaner, press the cord reel button to automatically rewind the cord. You can store your vacuum cleaner in a vertical position by sliding the hook on the nozzle into the slot on the underside of the vacuum cleaner. How to use Basic using method of the steam cleaner äÍ ÔÓθÁÓ, Ú¸Òfl By using the steam cleaning vacuum tool, you can do vacuum cleaning and steam cleaning simultaneously or individually, in an easy way. Always hold the steam safety switch during steam cleaning. Align the extension pipe (2) and the terminal part of the steam cleaning vacuum tool (3), and connect the two completely until you hear the "Click". If the steam cleaning vacuum tool and the extension are not completely connected, the nozzle will be pulled out or the steam will not be generated. Connect the hose (1) and the extension pipe (2) completely unit you hear the "Click" sound. 5 minutes and it will take a little longer for the cloth to get wet. You must operate the "STEAM" button after filling the water. When you press the "STEAM" button (4) one more time or press the "OFF" button (5), the steam will stop. To supply water, always unplug the power and put the hose handle on the floor. [. . . ] The bottom part can be separated to be cleaned. Since the bottom does not stick to the surface, vacuuming is easy. How to use àÒÔÓθÁÓ, ÌË ԰ÎÂÒÓÒ Follow the directions below for proper use. Set the suction power control switch to MAX POWER before vacuuming. [. . . ]