User manual LG V-WA266ND

[. . . ] Use the vacuum cleaner only for its intended use as described in these instructions. Do not use the vacuum cleaner without a dust bag. Change the dust bag before it is full in order to maintain the best efficiency. [. . . ] Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the cleaner parts. Do not block the suction or the exhaustion part. Switch the vacuum cleaner off at the machine before unplugging from the electrical outlet. Grasp the plug to disconnect cord from electrical outlet before changing the dust bag. The use of an extension cord is not recommended. AUTO MODE, in this case, increases the power automatically for sufficient suction. If you want to go back to the normal control type, just press "+" or "-" buttons. USING THE ACCESSORIES Open the tool storage cover upwards. CREVICE DUSTING UPHOLSTERY Crevice tool for radiators, crevices, corners, between cushions. Dusting brush for furniture, shelves, books, etc. Upholstery brush for cushions and drapery. 5 DJ68-00104A 10/18/01 11:53 AM Page 7 PARK POSITION Located in the top rear side of the vacuum cleaner, there is a nozzle support that can be used to park the nozzle during pauses in cleaning TRANSPORTING AND STORING THE VACUUM CLEANER For easy storage and transportation, this vacuum cleaner has a clip system built into body, which will keep the wand, hose and nozzle in an upright position. REPLACING THE DUST BAG 1) To open the dust cover of the dust bag compartment, press the clamper upwards(the clamper is located at the front of the dust cover). 2) Remove the dust bag from the cleaner 3) After removing the used dust bag, insert the cardboard bag collar of the new dust bag into its original position. 4) Press the dust cover down gently until the clamper relocks. 6 DJ68-00104A 10/18/01 11:53 AM Page 8 NOTE : Used dust bags can be sealed by removing the film from the paper and sticking over the suction opening. FOR CLOTH FILTER BAG After using, if the cloth filter bag is full of dust, clean the cloth filter bag and use it again. DUST-FULL INDICATOR If the "Dust-Full" indicator switch changes to "RED" while you are cleaning, the dust bag is full and must be replaced. NOTE : If the "Dust-Full" indicator continues to display "RED" even after changing the dust bag, turn the cleaner off and check whether the hose, tube or nozzle is clogged. MAINTENANCE OR REPLACEMENT OF THE FILTERS INLET FILTER The secondary filter, located behind the grille in the back of dust bag compartment, protects the motor from dirt particles. Do not allow the filter to become clogged. Suction power reduction or motor damage may result. If filter becomes dirty, pull off the grille and lift out filter. After cleaning the secondary filter attach it in place. NOTE : The filters must be completely dried before being replaced in the dust compartment. 7 DJ68-00104A 10/18/01 11:53 AM Page 9 OUTLET FILTER Open the dust cover and lift off the grille. For HEPA Filter Type For Micro Filter Type HEPA Filter Grille Filter Micro Filter Preliminary Filter Grasp filter and pull it out with preliminary filter. After cleaning preliminary filter, reposition new filter and preliminary filter by reversing this procedure. Preliminary Filter Grasp grille filter and pull it out with preliminary filter. [. . . ] After cleaning preliminary filter, reposition new filter and preliminary filter by reversing this procedure. Preliminary Filter Grasp grille filter and pull it out with preliminary filter. After cleaning preliminary filter, reposition new filter compartment and preliminary filter by reversing this procedure. TRANSPARENT TUBE Transparent tube prevent the tube and hose from being clogged by obstacle like as socks and clothes. Remove the alien substance with a stick from it. [. . . ]