User manual LG V2620DE

[. . . ] Read and follow all instructions before using your vacuum cleaner to prevent the risk of fire, electric shock, personal injury, or damage when using the vacuum cleaner. This guide do not cover all possible conditions that may occur. Always contact your service agent or manufacturer about problems that you do not understand. This appliance complies with the following EC Directives :-73/23/EEC, 93/68/EEC-Low Voltage Directive­89/336EEC ­EMC Directive. [. . . ] personal injury or product damage could result. You should grasp the carrier handle when you are moving the vacuum cleaner. If after emptying the dust tank the indicator light is on(red), clean the dust tank. Make sure the filters (exhaust filter and motor safety filter) are completely dry before replacing in the machine. Do not dry the filter in a clothes dryer. Do not push or pull the lever on the vacuum cleaner If the lever is damaged, the vacuum cleaner may not work properly and indicator light may flash red and alarm may sound although dust tank is not full. in this case , contact LG Electronics Service Agent <Do not push or pull the lever> If the vacuum cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner. check the vacuum cleaner for possible source of overheating such as a full dust tank , a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch. How to use Assembling vacuum cleaner äÍ ÔÓθÁÓ, Ú¸Òfl ë· Push the nozzle into the telescopic pipe. When you press the "STEAM" button (4) one more time or press the "OFF" button (5), the steam will stop. To supply water, always unplug the power and put the hose handle on the floor. Use the measuring cup to pour 250cc of water and then close the water hole cap tightly. When attaching the cloth, you must always turn off the system power. After attaching the cloth on the cloth board, install it on the nozzle for steam cleaning. Be careful because the cloth board can be hot. After aligning the vacuum tool with the cloth board, press it from the top. connect after you hear the clicking sound. The cloth must be attached on the cloth board for the vacuum tool and the cloth board to be connected. To prevent safety accidents during steam cleaning, if you do not press the steam safety switch within 30 seconds, the unit will recognize that the cleaning has been completed and turn off the power. If you want to use the steam again, press the "STEAM" button one more time. [. . . ] When removing the water, you can easily empty the water by separating the nozzle from the pipe. Store like this after using the cleaner èÓÒΠËÒÔÓθÁÓ, ÌËfl ÔË· When you pull up the extension pipe, it will be fixated after you hear the click sound. When you press the steam vacuum tool button, you can freely use the extension pipe. This nozzle picks up even dust inside through beating. [. . . ]