User manual LG VC9190DT

[. . . ] This information contains important instructions for the safe use and maintenance of the vacuum cleaner. Especially, please read all of the information on page 4, 5, 6 for your safety. Please keep this manual in an easily accessible place and refer to it anytime. 13 Utiliser la brosse sols durs et moquettes et la brosse parquet Using all floor and mini turbine nozzle . [. . . ] D on 't grasp the tank handle when you are moving the vacuum cleaner. The vacuum cleaner's body may fall when separating tank and body. personal injury or product damage could result. You should grasp the carrier handle when you are moving the vacuum cleaner. M ake sure the filters (exhaust filter and motor safety filter) are completely dry before replacing in the machine. D o not dry the filter in an oven or microwave. D o not dry the filter in a clothes dryer. If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent to avoid a hazard. T his appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor overheating. If the vacuum cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner. Check the vacuum cleaner for possible source of overheating such as a full dust tank, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch. If the vacuum cleaner still does not run, contact a qualified electrician. Push the nozzle into the telescopic pipe. Push the hose handle firmly into the telescopic pipe. Connecting the hose to the vacuum cleaner Relier le tuyau à l'aspirateur Push the fitting pipe on the flexible hose into the attachment point on the vacuum cleaner. To remove the flexible hose from the vacuum cleaner, press the button situated on the fitting pipe, then pull the fitting pipe out of the vacuum cleaner. Pull out the power cord to the desired length and plug into the socket. Place the control knob of the hose handle to the required position. [. . . ] Since this vacuum nozzle has been made exclusively for cleaning beds, blankets and upholstery, use it only for these cleaning purposes. (Using it to clean the floor may result soiling it or a drop in performance, do not use it for such purposes. Follow the instruction below for through washing. (Do not soak the entire body of the vacuum nozzle in water, it may cause the vibrator to malfunction) Press the button on the rear side of the vacuum nozzle to separate the bottom plate. [. . . ]