User manual LG VCA701HER

[. . . ] Do not allow it to use as a toy, injury could result. Do not continue to the cleaner if any appears to be faulty, missing or damaged. In these cases, contact an approved LG Electronics Service Agent. Repairs, when necessary, must be performed at an approved LG Electronics Service Agent. [. . . ] For appliances which come with mains lead and plug moulded on: the plug moulded on to the cable incorporates a fuse. For replacement use a 13 amp BS 1362 fuse. Only ASTA approved or certified fuses should be used. The plug must not be used if the fuse cover/carrier is lost. A replacement cover carrier must be obtained from authorised electrical goods retailers. -4- PARTS AND FEATURES It is important to know your vacuum cleaner's parts and features to assure its proper and safe use. Review these before using your cleaner. Telescopic handle Switch Carry handle Dust bin release button Dust bin cover button Dust bin Nozzle hose Height adjustment knob Telescopic release lever Exhaust filter Quick release cord hanger Dusting brush Crevice tool Mini nozzle (Option: ONLY VF5720***) Body release pedal Cord hook Motor protector -5- TELESCOPIC HANDLE RELEASE Release the telescopic handle by pulling telescopic release lever up with fingers and pulling up the telescopic handle. To lower the telescopic handle pull the telescopic release lever up with fingers and push down on the telescopic handle. Note : For your convenience, adjust telescopic handle height properly to your height. Telescopic handle Telescopic release lever CORD RELEASE Turn the quick release cord hanger to either side to release the power cord. To store the power cord, wrap the power cord around the quick release cord hanger and hook, and clip the plug onto the power cord with cord holder. Quick release cord hanger Cord holder Cord hook Plug shape: NORTH AMERICA UK AUSTRALIA EU ISRAEL -6- SWITCH OPERATION Switch operation · Off · Floor: Hard floors (Agitator off) · Carpet: Agitator on WARNING Personal injury hazard To avoid personal injury, do not turn switch On/Off if the vacuum or your hand is wet. BODY RELEASE AND POSITIONS Release the vacuum body by pressing down on the body release pedal with your foot and pulling back and down. Body release pedal RECOMMENDED PILE HEIGHT SETTINGS To select a pile height setting : Turn off cleaner first. Select a pile height setting by using height adjustment knob. Rotate the adjustment knob to the correct setting position. Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. VACUUM STORAGE To store the vacuum cleaner when it is not used, assemble its cord and return its telescopic handle to its lower space saving position. WARNING Electrical shock and personal injury hazard. Wrapping the cord too tightly puts stress on the cord and can cause cord damage. A damaged cord is an electrical shock hazard and could cause personal injury or damage. DUST BIN ASSEMBLY Dust bin lid The dust bin lid covers up the dust bin. Air filter The air filter the fine dust from dust bin. Inner shield The inner shield traps large dirt and debris that is picked up by the suction. Dust bin Where dirt is collected. Inner shield Dust bin lid Air filter Dust bin -11- DUST BIN CLEANING For best performance always empty the dust bin when the dust is full. WARNING Electrical shock and personal injury hazard. Always unplug power cord from electrical outlet before performing any service on vacuum. When the alarm sounds, check the dust bin. If the dust bin is full, empty the dust bin. Dust bin cover Dust bin cover button Note : When replacing the dust bin in the vacuum you need to push and snap it. Make sure that dust bin is fully engaged otherwise suction power could be low. TO CLEAN DUST BIN remove catch on dust bin cyclone and separate the inner shield from the dust bin cover as shown. [. . . ] Loop the other end of belt onto the belt pulley on the left end of agitator. To replace the nozzle bottom plate, follow the NOZZLE BOTTOM PLATE REMOVAL / INSTALLATION section. (Page 14) -15- CLEANING EXTERIOR Unplug power cord from wall outlet. Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water and wrung dry. DO NOT clean tools in dishwasher or clothes washer. Wash tools in warm soapy water, rinse and air dry. [. . . ]