User manual LG VCS442

[. . . ] 25 Contrôlez avant d'appeler le service après-vente What to do if your vacuum cleaner does not work . This guide do not cover all possible conditions that may occur. Always contact your service agent or manufacturer about problems that you do not understand. This appliance complies with the following EC Directives : 2006/95/EC Low Voltage Directive 2004/108/EC EMC Directive. [. . . ] failure to do so could result in product damage. • Do not dry the filter in an oven or microwave.  Failure to do so could result in fire hazard. • Do not dry the filter in a clothes dryer.  Failure to do so could result in fire hazard.  Failure to do so could result in fire hazard. • Do not use filters that is not dried. • If the power cord is damaged, it must be replaced  by an approved LG Electronics Service Agent to avoid a hazard. •  lways clean the dust bin after vacuuming carpet A cleaners or fresheners, powders and fine dust. These products clog the filters, reduce airflow and can cause damage to the cleaner. Failure to clean the dust bin could cause permanent damage to the cleaner.  o turn off , slide control knob to T OFF position. •  ress the cord reel button to P rewind the power cord after use. •  lways empty the dust tank when A the dust tank level reaches the MAX line.  ppuyez sur le bouton de A rembobinage pour rembobiner le câble après utilisation. •  o store during vacuuming, for T example to move a small piece of furniture or a rug, use park mode to support the flexible hose and nozzle. - Slide the hook on the nozzle  into the slot on the side of vacuum cleaner. ➍  torage S Rangement •  hen you have switched off W and unplugged the vacuum cleaner, press the cord reel button to automatically rewind the cord. •  ou can store your vacuum Y cleaner in a vertical position by sliding the hook on the nozzle into the slot on the underside of the vacuum cleaner. 12 How to use Using carpet and floor nozzle Comment utiliser Utiliser la brosse sols durs et moquettes et la brosse parquet Carpet Tapis Pedal Pédale Floor Sol ➊  arpet and floor nozzle (depend on model) C Brosse sols durs et moquettes (selon le modèle) •  he 2 position nozzle T This is equipped with a pedal which allows you to alter its position according to the type of floor to be cleaned.  arpet or rug position C ) to lower brush. Press the pedal ( •  ard floor position (tiles, parquets floor) H Both pedal position are suitable. [. . . ] ➍  traighten the punch bar S on the lower section. ➎ nsert the attachment I projections on bottom plate to the vacuum nozzle grooves. • Do not use filters that is not dried. ➌  ow to assemble H Méthode de remontage • Insert the motor protection filter to the filter case. [. . . ]