User manual LG VP0716WNV

[. . . ] Vacuum Cleaner OWNER'S MANUAL MODEL: VP07**WNV Please read carefully and thoroughly the operating instructions and safety precautions before installing and operating your vacuum cleaner. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your vacuum cleaner to prevent the risk of fire, electric shock, personal injury, or damage when using the vacuum cleaner. This guide do not cover all possible conditions that may occur. Always contact your service agent or manufacturer about problems that you do not understand. This appliance complies with the following ECDirectives :-73/23/EEC, 93/68/EEC-Low Voltage Directive89/336EEC EMC Directive. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "WARNING" or "CAUTION. " These words mean: WARNING CAUTION This symbol will alert you to hazards or unsafe practices which could cause serious bodily harm or death. [. . . ] Pull the dust bag flange over the inlet stub, taking care not to damage the bag. Re-position the head onto the tank, and clip in place. Insert the larger end of the flexible hose into the front inlet on the tank and lock in place. Push the required attachment onto the free end of the hose. 4. 8 Switch the motor to vacuum only (position: . ) 4. 9 . When you have completed vacuuming, turn the switch to `Off`. (position `I'), and unplug from power supply. Regularly check the dust bag and dispose of safely when it is 2/3 full. The bag is manufactured so that only air, not dust, will pass through the paper and as such the dust bag must not be re-used. DO NOT use the dust bag and re-usable filter for wet or sharp materials. 4. Ensure you read, understand and apply Section 1 `Safety Instructions'. Reminder: DO NOT vacuum hazardous substances. Use of an incorrect dust bag will invalidate your warranty. 4. 1. Ensure the machine is unplugged 7 suction action when the tank has reached its maximum capacity. The user will notice an increase in motor noise. When this happens, turn off the machine, disconnect from power supply, remove the head from the tank and empty the liquid into a suitable receptacle or drain. To continue vacuuming, refit the head and proceed. After wet vacuuming, turn the machine off and remove plug from power supply. Empty the tank and clean/ dry the inside and outside before storage. After wet vacuuming the foam filter must be removed and the re-usable filter or the dust bag must be fitted before dry vacuuming again. 5. Ensur the machine is unplugged e from the power supply. Make sure the tank is clean and free from dust and dirt. [. . . ] ZML nK Wb s "UN lML Wb WU VM WMJL l{ , r nOEM bM , bMB . r qH ULzoe WU v pc UOI b oeR sJL YO s UN vuL WML UOG lD b߫ LG Electronics. ZML w uu u UL WOdNJ WMJL b߫ <UIKL l jI UNb߫ jI qOb c . WIOb 4 dc UJ_ s qJ Q fUI b WOdNJ WbB v pc UOI b oeR b oeR b ZML nK Wb WU fUI sJ r . . . Uu v pc UOI VOd h wzUdNJ qBU , UUM . [. . . ]