User manual LG VR8600RB HOM-BOT

[. . . ] About Filter ■ Dust Bin Filter It is recommended to clean the dust bin filter with HEPA 11 once a week. During the cleaning, clean thoroughly with cleaning brush and the cleaner. When it is washed with water, the cleaning performance will be degraded. Make sure to install the dust bin filter (HEPA filter, sponge filter) to the dust bin after the cleaning. If the dust bin or dust bin filter is not installed, dust may enter inside Roboking and cause disorder. -10- Cautions and Methods during the Usage 3. [. . . ] 8. 2  andling: It may cause the falling out of soldered area or welded area, so be careful H during the handling of the battery pack. 8. 3  hort circuit: Be careful of the short circuit of the batter pack. If there is a short circuit S in the batter pack, over-current will flow and there is a risk of device damage or heat generation. E 8. 4  xposure to moist environment: Do not use the battery pack in a moist state. The current leakage by the moist of the insulating material inside the pack may cause degradation of the performance. 8. 5  echarging station: Use only the recharging station specified for this battery pack. R Using other recharging station other the specification may cause heat generation, flame, or an explosion. -36- Safety Cautions and Verifications During the Repair 1.  ake sure to convert the power to “Off” state when you check, disassemble, or repair M the cleaning robot. (Turn off the power button at the left backside of the main body. ) 2. The circuits used in the cleaning robot are sensitive to static electricity, so repair in an  environment without static electricity. (Wear antistatic gloves and sleepers. ) 3.  uring the electricity applied inspection of the circuit, do not have pin or coin contact D with the recharging part. Make sure to use the designated parts for replacement parts during the repair.  ake sure to check the damage of the power cable, etc. If the sheath M is peeled or if there is a short circuit, make sure to firmly connect it and wrap it with insulation tape.  heck the parts with problems using the diagnosis program before and after the repair.  heck if the upper part and lower part of the main body are completely combined. (It C may cause degradation of the suction power or noise generation. Especially, check the handling of the lead line. ) 9.  ake sure to carry out the insulation test of the motor. (It is OK if it is 5MΩ or more M between the impeller cover of the motor and the power connector. ) -37- How to Disassemble/Assemble Major Parts ■ Battery Disassembly Make sure to disassemble the battery before the disassembly/assembly work. After setting power switch to OFF, then unscrew two battery screws by using a (+) driver and disassemble the battery. Battery is at the bottom when the main body is flipped over Disassemble the battery by unscrewing the bolts using a (+) driver Hold the bottom part and lightly hit the set to the table to take out the battery Take out the separated battery out of the set Separate by pressing the battery connector hook with hand Battery is completely separated from the set -38- How to Disassemble/Assemble Major Parts ■ Cover Assembly Open cover by pressing point pressing the Separate dust bin from the set 1. [. . . ]  isassemble power cord from D condenser Disassemble after removing 2 screws 2. Disassemble BODY BASE Push up with both thumbs 3. Disassemble COVER FRONT Push up lightly the receptacle with ( - ) driver 5. Separate wire -59- While slowly rotating to one direction, separate the spring Separate the connector 7. [. . . ]