User manual LG VTCA261NT

[. . . ] When using an electrical appliance, basic precautions should be observed, including the following: Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and before conducting maintenance. Do not operate the robotic vacuum cleaner or charger if it has been damaged in any way. If the cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped in water, return it to a customer care center. [. . . ] When the product is initially purchased, it will take about 120 minutes to fully charge the battery and will run for about 90 minutes. When charging the battery while the battery is over-heated, the charging time can increase. Measures to take when charging is not smooth. When the robotic vacuum cleaner cannot be automatically charged, check the following: - Turn the Power Switch at the bottom of the robotic vacuum cleaner off and on (Reset). - Re-plug the power of the charger (Reset). - Check whether there are any foreign substances on the charge connector and wipe the charge connector on the main unit and the charger with a dry cloth. - Check whether there are objects near the charger that are strong reflectors. When separating the robotic vacuum cleaner from the charger, it will discharge naturally. - Charge the robotic vacuum cleaner through the charger , if possible. (When leaving your home unattended for a long period of time due to a business trip, travelling etc. , turn off the Power Switch of the robotic vacuum cleaner and unplug the power of the charger to store them. Install the Smart gate in front of the area you want to block access from the robotic vacuum cleaner. - Install the Smart gate so that the distance detection sensor can form an invisible barrier that the robotic vacuum cleaner cannot cross. Using Guard (virtual door) mode The Smart gate forms an invisible door that the robotic vacuum cleaner cannot cross until current room is complete cleaned. The Smart gate opens the invisible door when cleaning the room is complete. Set the fence length using the distance control switch. Install the Smart gate at the entrance of the room to be cleaned. - Install the Smart gate so that the distance detection sensor can form an invisible barrier that the robotic vacuum cleaner cannot cross. When not using the Smart gate, turn the power off. (Specifications: Type D (LR20) alkaline batteries ) You can additionally purchase an Smart gate from Samsung Electronics customer care Co. Since an invisible barrier is formed to prevent the robotic vacuum cleaner from running against the Smart gate, installing the Smart gate within 30 cm of the outside walls is recommended. Robotic vacuum cleaner uses 3 types of infrared devices and a device may not Remote Control Smart gate Charger work in front of another device with a higher priority. [. . . ] Off and then set the Smart gate to a desired mode. Smart gate is too (2 type D (LR20) alkaline short. When the robotic vacuum In the display panel, From forced to seperate from charger cleaner is seperated or pressed 30, 29, 28, . During the charging, after the number is 30-second counts it is returning counted down. [. . . ]