User manual LG W2242PM-SF

[. . . ] Make sure to read the Important Precautions before using the product. Keep the User's Guide(CD) in an accessible place for future reference. This unit has been engineered and manufactured to ensure your personal safety, however improper use may result in potential electrical shock or fire hazards. In order to allow the proper operation of all safeguards incorporated in this display, observe the following basic rules for its installation, use, and servicing. [. . . ] The product may fall and get damaged or injure your foot. Before setting up the monitor, ensure that the power to the monitor, the computer system, and other attached devices is turned off. Ergonomic It is recommended that in order to maintain an ergonomic and comfortable viewing position, the forward tilt angle of the monitor should not exceed 5 degrees. Please be cautious and avoid contact between the monitor head and the Stand Base when rotating the screen to access the Pivot function. If the monitor head touches the Stand Base, then the Stand Base could crack. Before setting up the monitor, ensure that the power to the monitor, the computer system, and other attached devices is turned off. If you want to use the cable holder to let your cables together, please put them through right as shown. For if you don't do like that, you cannot use Pivot function smoothly. Make sure to turn off the computer and product. Connect the cable as below sketch map form 1 to 2 . nOTE This is a simplified representation of the rear view. Connect DVI Cable This rear view represents a general model; your display may differ from Connect Dsub Cable (PC) the view as shown. User must use shielded signal interface cables (D-sub 15 pin cable, DVI Connect Dsub Cable (Mac) cable) with ferrite cores to maintain standard compliance for the product. For Apple Macintosh use, a separate plug adapter is needed to change the 15 pin high density (3 row) D-sub VGA connector on the supplied cable to a 15 pin 2 row connector. Button on the front switch panel to turn the power on. When monitor power is turned on, the 'Self Image Setting Function' is executed automatically. This function provides the user with optimal display settings. When the user connects the monitor for the first time, this function automatically adjusts the display to optimal settings for individual input signals. When you encounter problems such as blurry screen, blurred letters, screen flicker or tilted screen while using the device or after changing screen resolution, press the AUTO/SET function button to improve resolution. Function Use this button to enter or exit the On Screen Display. Use this button to make D-Sub or DVI connector active. This feature is used when two computers are connected to the display. [. . . ] " Press the button to reset immediately. If this does not improve the screen image, restore the factory default settings. If necessary, perform the white balance function again. This function will be enabled only when the input signal is an analog signal. [. . . ]