User manual LG W2252S-PF

[. . . ] IF NOT, THE WALL STRUCTURE MUST BE REINFORCED. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE INSTALLATION INSTRUCTIONS, MUST BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY, OR EVEN DEATH. SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE INSTALLATION OF THIS PRODUCT. [. . . ] USE PROPER SAFETY GEAR AND TOOLS FOR THE INSTALLATION PROCEDURE TO PREVENT PERSONAL INJURY. PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS SHOULD BE READ AND COMPLETELY UNDERSTOOD. THE INSTALLATION INSTRUCTIONS MUST BE READ TO PREVENT PERSONAL INJURY AND PROPERTY DAMAGE. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REFERENCE. WARNING: WARNING: Indicates that the power plug is to be disconnected from the power outlet. Safety precautions must be taken at all times. Warning and Caution statements. Contact Sony questions. Electronics with any Do not install on a structure that is prone to vibration, movement or chance of impact. Failure to do so could result in damage to the display and/or damage to the mounting surface. Do not install near heater, fireplace, direct sunlight, air conditioning or any other source of direct heat energy. Failure to do so may result in damage to the display and could increase the risk of fire. At least two qualified people should perform the installation procedure. Injury and/or damage can result from dropping or mishandling the plasma display. Use the two (2) 6/32" x 1" handy box screws (supplied) for your installation needs. Solid Structure #10 Wood Screws #10 Wood Screws Electrical Opening Frontplate #10 Wood Screws #10 Wood Screws Figure 2 Page - 6 - Installation Manual SFM2 Attaching the Adapter Plate and the Backplate Cover Line up the mounting points (Figure 3). Attach the frontplate to the adapter plate using four (4) M4 x 10mm Phillips Head screws (Figure 4). Do not tighten the screws until all four are inserted. Once the screws are inserted, tighten the screws down. CAUTION: Do not over tighten the M4 screws to the monitor. Failure to do so could result in damaging the threads and monitor. At this time, loosely install the two (2) M6 x 12mm Security Screws (Figure 4). 4. Adapter Plate Frontplate Figure 3. Mounting Box/ Adapter Plate Combination Installation Manual Page - 7 - SFM2 Adapter Plate M4 x 10mm Phillips Head Screws M4 x 10mm Phillips Head Screws Frontplate M6 x 12mm Phillips Head Security Screws Figure 4 Page - 8 - Installation Instructions SFM2 Attaching the Adapter Plate /Backplate Cover to the Display 1. Place the display on a flat and soft surface and locate the four mounting points (Figure 5). Attach the Adapter Plate to the back of the display using four (4) M6 x 10mm Phillips Head screws (Figure 6). [. . . ] Attach the Adapter Plate to the back of the display using four (4) M6 x 10mm Phillips Head screws (Figure 6). CAUTION: DO NOT OVERTIGHTEN THE SCREWS. Figure 5. Installing the Adapter Plate/ Mounting Box Adapter Plate Ultra Flat Mount Figure 6. Installation Complete Installation Instructions Page - 9 - SFM2 Attaching the Display to the Backplate NOTE: For clarity purposes, the following illustrations will be shown without the adapter plate and display attached. [. . . ]