User manual LG WD-1041WFH

[. . . ] Tips and information about economical and ecological use of the machine are marked with this symbol. 2 Contents Warnings Disposal 4-5 5 Maintenance Bodywork Detergent dispenser drawer Cleaning of the drainage area Water inlet filter Emergency emptying out Frost precautions 22-23 22 22 22 23 23 23 Tips for environmental protection 5 Technical specifications Installation Unpacking Hydraulic connection Levelling Electrical connection 6 7-8 7 7 8 8 Something not working? 24-26 Your new washing machine Description of the appliance Detergent dispenser drawer 9 9 9 Use Control panel Controls Washing hints Sorting the laundry Temperatures Before loading the laundry Maximum loads Laundry weights Removing stains Detergents and additives Quantity of detergent to be used International wash code symbols Operating sequence Washing programmes 10 10 10-12 13 13 13 13 13 13 13 14 14 15 16-18 19-21 3 ENGLISH Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation · All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. Refer to the relevant paragraph in the instruction book. [. . . ] Blood: treat fresh stains with cold water. For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Remove any residual marks from white fabrics with bleach. wash temperature 30°C 60 40 40 30 Hand wash Do not wash at all Bleaching Bleach in cold water Do not bleach Ironing Hot iron max 200°C Warm iron max 150°C Lukewarm iron max 110°C Do not iron Dry cleaning Dry cleaning in all solvents Dry cleaning in perchlorethylene, petrol, pure alcohol, R 111 & R 113 Dry cleaning in petrol, pure alcohol and R 113 Do not dry clean high temperature low temperature Drying Flat On the line On clothes hanger Tumble dry Do not tumble dry 15 ENGLISH Operating sequence Before washing your first load of laundry, we recommend that you run a cotton cycle at 60° C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half of the normal amount of detergent into the main wash compartment and start up the machine. 1. Place the laundry in the drum Open the door by pulling the handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Select the required programme Turn the programme selector to the required programme. P0004 2. Measure the detergent Pull out the dispenser drawer until it stops. Measure the required amount of detergent, pour it into the main wash compartment and into the compartment marked . 5. Select the spin speed or RINSE HOLD option. R0070 3. Measure the fabric softener If required, pour fabric softener into the compartment marked (the amount used must not exceed the "MAX" mark in the drawer). Select the required option push button/s R0071 16 7. Select, if required, DELAY START option button Push DELAY START button as many times as necessary until the corresponding light to the required delay (8 H, 4 H) comes on. 9. [. . . ] · The correct wash programme has not been selected. · Too much laundry has been placed in the drum. · The transit bolts and packaging have not been removed. · The machine is in contact with the wall or furniture. [. . . ]