User manual LG WD-12215RD

[. . . ] · The safety of Your appliance complies with the industry standards and with legal requirements on the safety of appliances. However, as manufacturers, we feel it is our duty to provide the following safety notes. · It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. [. . . ] Turn the programme selector dial to O and then to the new programme position, press the button 6 to cancel the previous washing programme. Start the new programme by pressing the button 7 again. The washing water in the tub will not emptied out. Interrupting a programme Press the button 7 to interrupt a programme which is running, the corresponding light starts blinking. Press the button again to restart the programme. Cancelling a programme Turn the selector dial to O and then in the new selected programme. Press the button 6 to cancel the programme which is running. Now press the button 7 to start the new programme. Opening the door after the programme has started Press the button 7 to set the machine to pause. The corresponding message will appear on the display. If the door cannot be opened, this means that the appliance is already heating, that the water level is above the bottom edge of the door. In this case the door can not be opened. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone2), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Ink: depending on the type of ink, moisten the fabric first with acetone2), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. [. . . ] Water-stop device The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window «A» . Should this occur, turn the water tap off and refer to your Service Centre to replace the hose. A 45° 3. Set the hose correctly by loosening the ring nut. [. . . ]