User manual LG WD-14030

[. . . ] 1 Remove Packaging · The appliance is fitted with transit bolts to prevent internal damage during transport. · Packing and all transit bolts must be removed before using the washing machine. · When unpacking the base, be sure to remove the additional packing support in the middle of the base packing. 4 Electrical connection 6 Installation of drain hose Safety instuctions for the installation Install or store appliance where it will not be exposed to sub-zero temperatures or exposed to the weather. Fit ground of the washing machine correctly to conform with all statutory regulations and ordinances. [. . . ] The appliance must be positioned so that the plug is easily accessible. · Repairs to the washing machine must only be carried out by qualified personnel. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. · Do not install your washing machine in rooms where temperature below freezing may occur. The electronic control unit may become unreliable at temperatures below freezing point. · If the appliance is delivered in the winter months and temperatures are below freezing: Leave the washing machine standing at room temperature for a few hours before putting it into operation. Add 1 or 2 similar items to help balance the load. Rearrange load to allow proper spinning Owner`s Manual WD-14030FDS CAUTION Transit bolts Schraubenschlüssel The appliance is not intended for use by young children or infirm persons without supervision. Young Children should be supervised to ensure that they do not play with appliance. To prevent internal damage during transport, the special 4 bolts are locked. If they are not removed, it may cause heavy vibration, noise and machine to malfunction. 2 Remove the 4 bolts along with the rubber bungs by slightly twisting the bung. 5 Connecting water supply hose The hose supplied with the machine must be used. Old hoses may not be reused Water supply pressure must be between 1. 0-10 bar (100kPa~1000kPa) We recommend connecting most appliances to a dedicated circuit. That is, a single outlet supplying power only to the appliance concerned, without any additional outlets or branch circuits. Check the specifications of this owner`s manual. Overloaded wall sockets, loose or damaged wall sockets or extension cords, frayed power cords, damaged or cracked wire insulation are dangerous. Any of these conditions could result in electric shock or fire. Periodically examine the cord of your appliance, and if its appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer. Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, squashed in a jamb of a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance. We recommend to use a residual current operated device in the mains supply. CAUTION about location and moving This equipment is not designed for maritime use or for use mobile installations such as caravans, aircraft etc. Turn off the stopcock if the machine is to be left for any length of time (e. g. if you are going on holiday), especially if there is no floor drain (gully) in the immediate vicinity. If relocating the appliance use the original packing material. [. . . ] drawer Power ON with Then press and hold Rinse and Temp. button Press the Start/Pause button to start Tub Clean process After the cycle is complete, leave the door open to dry Open the lower cover Unplug the drain plug. Drain plug to Then open the filter pull out the hose by turning to the left Remove any extraneous matter from the pump filter After cleaning, turn the pump filter and insert the drain plug Close the lower cover cap Cleaning the dispenser drawer 5 Once you have finished cleaning, replace the drawer and run a rinse cycle without laundry. Delicate Hand Wash /Wool Quick 30 Refresh 30°C (Cold, 40°C) 40°C (Cold, 30°C) 30°C (Cold, 40°C) No Choose Less than 3. 0kg Select the Spinning speed Remove laundry - Open the door - Remove the laundry Less than 2. 0kg Beep on / off The Beep on/off function can be set only during the washing cycle. To set the Beep On/Off function follow the below steps. [. . . ]