User manual LG WD-8013F

[. . . ] It is imperative that this information is observed. 0 1. This symbol guides you step by step through the operation of the appli- ance. . . . 3 2 Next to this symbol you will find additional information and practical tips on using the appliance. Tips and information on economical and environmentally responsible use of the unit are identified with the clover leaf. [. . . ] When doing so, use warm water. 0 Detergent Drawer The detergent drawer should be cleaned from time to time. Pull the detergent drawer out as far as it will go. Remove the detergent drawer by pulling sharply. Take the conditioner insert out of the middle compartment. Clean the conditioner insert under running water. 5. Clean the compartments with warm water from the rear side. Push on the conditioner insert as far as it will go so that it is securely in place. 26 Operating Instructions 7. Use a brush to clean the entire rinsing-in section of the washing machine, particularly also the nozzles on the top side of the rinsingin chamber. 8. Set the detergent drawer into the guide tracks and push in. Washing Drum The washing drum is made of stainless steel. Rusting foreign bodies in the washing can cause rust deposits on the drum. Do not clean the stainless steel drum with decalcifying agents containing acids, scouring agents containing chlorine or iron, or steel wool. Use the exact quantities recommended by the detergent manufacturer. The washing solution of the main wash produces a great deal of lather. Too much washing powder/ liquid was probably used. 29 Operating Instructions Problem Possible Cause The transport packaging has not been removed. The height-adjustable screw feet are not correctly set. The washing machine vibrates during operation or wobbles. Remedy Remove transport packaging according to the installation and connection instructions. Adjust the feet according to the instructions for installation and connection. There is very little washing in This does not impair the the drum (e. g. The water could not be completely pumped out before spinning because the drain hose is bent or the drain pump is blocked. Check along the drain hose and remove any kinks present, or clean the drain pump and, if necessary, remove foreign bodies from the pump housing. The screw connection on the Tighten the inlet hose screw inlet hose is leaky. The drain pump cover is not correctly closed. Water runs out under the washing machine. Check the drain hose and replace it if necessary. Close cover correctly. Interrupt the programme and remove washing from Washing is stuck in the door. [. . . ] Terlaton Street 42/44 1011 Riga Tel. : 371 2 297821 Fax: 371 2 821286 Lthuania Electrolux Lthuania Verkui 29 2600 Vilnus Tel. : 372 272 3326 Fax: 372 272 3366 Poland Electrolux Poland Sp. Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Russia Electrolux Russia Ltd. 16 Olympiysky prospekt 129090 Moscow Tel. : (095) 937 7837 Fax: (095) 926 5513 45 Warranty conditions / Customer service centres Israel Electricity & Electronic Services-Evis LTD. Raanana, Industrial area 43654 Tel: 972-9-7448118 Fax: 972-9-7603618 e-mail:evis@evis. co. il Malaysia Arzbergh Engineering No. [. . . ]