User manual LG WD-14800RD

[. . . ] It is imperative that this information is observed. 0 1. This symbol guides you step by step through the operation of the appli- ance. . . . 3 2 Next to this symbol you will find additional information and practical tips on using the appliance. Tips and information on economical and environmentally responsible use of the unit are identified with the clover leaf. [. . . ] Clean the compartments with warm water from the rear side. Push on the conditioner insert as far as it will go so that it is securely in place. 27 Operating Instructions 7. Use a brush to clean the entire rinsing-in section of the washing machine, particularly also the nozzles on the top side of the rinsingin chamber. 8. Set the detergent drawer into the guide tracks and push in. Washing Drum The washing drum is made of stainless steel. Rusting foreign bodies in the washing can cause rust deposits on the drum. Do not clean the stainless steel drum with decalcifying agents containing acids, scouring agents containing chlorine or iron, or steel wool. Our Customer Service can provide suitable agents. Remove any rust deposits on the drum using a stainless steel cleaning agent. 0 Main door 0 Check on a regular basis to see if deposits or foreign objects are present in or at the rubber sleeve behind the door, and remove. 28 Operating Instructions Cleaning the drain pump Paper clips, nails and so on can sometimes get into the washing machine with the washing and remain in the drain pump casing. Fluff and strands of fabric can gather on these items and block the drain pump. Therefore the drain pump should be cleaned at least once a year. Switch off the washing machine and pull out the mains plug before cleaning the drain pump!The water could not be completely pumped out before spinning because the drain hose is bent or the drain pump is blocked. Check along the drain hose and remove any kinks present, or clean the drain pump and, if necessary, remove foreign bodies from the pump housing. The screw connection on the Tighten the inlet hose screw inlet hose is leaky. The drain pump cover is not correctly closed. Water runs out under the washing machine. Check the drain hose and replace it if necessary. Close cover correctly. Interrupt the programme and remove washing from Washing is stuck in the door. Seal the emergency drain hose correctly (see section Emergency drain hose is not "Carrying out an Emergency correctly sealed or is leaking. If the emergency drain hose leaks contact customer service. Cancel o (RINSE HOLD). The washing machine does not spin; there is water in the drum. Release q (SOAKING) butSoaking programme has finton (main wash programme ished. will follow). 31 Operating Instructions Problem Softener has not been flushed into machine; drawer for care agent is filled with water. Possible Cause Remedy The softener insert has not Wash the washing powder been correctly positioned indrawer and position the sofside the care agent comparttener insert firmly. [. . . ] 16 Olympiysky prospekt 129090 Moscow Tel. : (095) 937 7837 Fax: (095) 926 5513 46 Warranty conditions / Customer service centres Israel Electricity & Electronic Services-Evis LTD. Raanana, Industrial area 43654 Tel: 972-9-7448118 Fax: 972-9-7603618 e-mail:evis@evis. co. il Malaysia Arzbergh Engineering No. 49A/B, Jalan Petaling Utama 7 4600 Petaling Jaya Tel. : 3 795 1084 Fax: 3 795 1082 Saudi Arabia Alia Trading Corporation P. O. Box 4101 King Abdul Aziz Street Riyadh Tel. : 4645977 Al Nahas Est. [. . . ]