User manual LG WF-2007T

[. . . ] Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon). Curtains and delicate clothing, dresses, skirts, shirts and blouses. Slightly to normally soiled textiles made of cotton and/or synthetics. [. . . ] Programme Duration without "Rapid" 2:05 4:00 2:10 2:50 2:00 4:00 2:05 1:50 0:45 1:00 0:15 0:45 0:35 (hrs : min) with "Rapid" ­ 2:30 *** 2:00 *** ­ 1:14 0:59 ­ ­ ­ ­ ­ Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also "Troubleshooting Guide" in your Instructions for Use). * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programmes for Energy Label. *** Automatic adaption of programme duration after detection of wash load. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. Add detergent and eventual additives as described on the front page and in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The lamp next to the "Start(Pause)" button blinks. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. · Once having pressed the "Start(Pause)" button, the countdown of the time delay begins. When the programme starts, the start delay indicator light goes off and is replaced by the programme sequence indication. · After the "Start(Pause)" button has been pressed, the number of hours preselected can be reduced by pressing again the "Start delay" button. To cancel the "Start delay" . . before you press the "Start(Pause)" button: · Turn the programme selector to another position or press the "Reset" button. . . after having pressed the "Start(Pause)" button: · Press the "Reset" button for at least 3 second. The start delay indicator light goes off. PROGRAMME START Open the tap and press the "Start(Pause)" button. The indication lamp next to the "Start(Pause)" button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. · Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. [. . . ] PROGRAMME END · All the lights of the programme sequence indicator are off, and the "Door open" indication lights up. Turn the programme selector to the "Off/O" position. Open lid and drum and unload the machine. Leave the lid open for some time to allow the interior of the machine to dry. [. . . ]