User manual LIEBHERR CCE 2330

[. . . ] Operating instructions Chest freezer Page 8 GB 7082 241-01 GT 56 The appliance contains reusable materials and should be disposed of properly - not simply with unsorted household refuse. Appliances which are no longer needed must be disposed of in a professional and appropriate way, in accordance with the current local regulations and laws. disposal notes · To prevent injury or damage to the unit, the appliance should be unpacked and set up by two people. safety instructions and warnings · In the event that the appliance is damaged on delivery, contact the supplier immediately before connecting to the mains. [. . . ] the temperature display will also flash. Temperature setting buttons On/Off button Audible warning on/off button Child lock LED SuperFrost LED SuperFrost button Temperature display The audible warning device is switched off by pressing the ALARM button. The audible warning device helps to protect the frozen food and to save energy. Audible warning signal If nA appears in the display, this means that the freezer temperature has risen too high during the last few hours or days due to a power failure. Power failure display - The two illuminated dashes of the digital temperature display will light up until a temperature of 0°C is reached. - If the temperature is below 0°C, the digital temperature display will show the temperature inside the appliance. To switch the appliance on: Press the ON/OFF button until the temperature display lights up. You are recommended to clean the appliance before switching it on for the first time (see Cleaning). Switching the appliance on and off If you press the ALARM button whilst the display is reading nA, the highest temperature registered during the power failure will be displayed. Check the quality of the food and its suitability for consumption in case it has become too warm or even defrosted. The highest temperature will appear for appox. After that, the actual temperature in the freezer will re-appear. The display can be switched off by pressing the ALARM button. To switch the appliance off: Press the ON / OFF button for approx. 3 seconds so that the temperature display goes out. In set-up mode you can set the child lock and adjust the brightness of the display. The child lock is designed to protect the appliance from being switched off accidentally. additional functions Activating the child lock · To reduce the temperature: Press the bottom button Down. To increase the temperature: Press the top button Up. - While you are entering the temperature, the set temperature will flash on the display. - You can change the settings in increments of 1°C briefly pressing the button again. If the buttons are held down the temperature setting will change faster. [. . . ] The temperature is not low enough: Is the temperature setting correct (see Setting the temperature)?Have excessive amounts of fresh food been placed in the appliance?Observe the temperature display for a further 24 hours. Does the separately installed thermometer show the correct reading? [. . . ]