User manual LIEBHERR CTNES 4753 PREMIUM NOFROST

[. . . ] Take the packaging material to an official collection point. - in staff kitchenettes, bed and breakfast establishments, - by guests in cottages, hotels, motels and other forms of accommodation, - in catering and similar services in the wholesale trade. Use the appliance solely as is customary within a domestic environment. All other types of use are inadmissible. The appliance is not suitable for storing and cooling medicines, blood plasma, laboratory preparations or similar substances and products covered by the 2007/47/EC Medical Devices Directive. Any misuse of the appliance may result in damage to or spoilage of stored goods. [. . . ] The permissible voltage and frequency are indicated on the type plate. The position of the type plate is shown in the section entitled Description of the appliance. The socket must be properly earthed and protected by a fuse. The tripping current of the fuse must be between 10 A and 16 A. Electrical connection Press the Up/Down button 6 until the desired value is displayed in the temperature display 5. Note After a certain period of operation, the interior temperature will adjust to the value which has been set. The socket must not be situated behind the appliance and must be easily accessible. Do not connect the appliance using an extension cable or extension socket. Do not use stand-alone inverters (conversion of direct current to alternating current/threephase current) or energy-saving plugs. Risk of damage to the electronic control system! 12 Audible warning on/off button Audible door alarm If an appliance door is left open for more than 60 seconds, the audible warning signal will sound. Press the audible warning on/off button 8 to cancel the alarm. The alarm switches back to standby when the door is shut. The appliance is equipped with an alarm function. You can re-arrange the storage shelves as required. Lift the glass shelf, align the recess over the support and replace the shelf in a higher or lower position. Equipment GB Audible/visual temperature alarm If the temperature in the freezer compartment rises too high, the audible warning signal will sound and the LED in the audible warning on/off button 8 will flash. This can be caused by: • the freezer door being left open for a long time, allowing warm ambient air to enter; • a long power failure; • a fault in the appliance. In each case, make sure food has not thawed or perished. The light intensity of the LED light corresponds to laser class 1/1M. Important If the cover is removed, do not look directly at the light through optical lenses from close distance. This can damage your eyes. Interior LED light Storage example Cooling 1 butter, cheese 2 eggs, cans, tubes 3 bottles 4 frozen food, ice cubes 5 meat, sausage products, dairy products 6 baked goods, pre-cooked meals, drinks 7 fruit, vegetables, salad If the lamp is defective, it can be replaced taking into account the following points. 1. Pull out the plug or switch off the fuse. 2. Press the light cover together at the sides (1), lift out and unclip at the back (2). When using an LED lamp Replacing the lamp Note • Food which gives off or absorbs odours and flavours as well as liquids should always be stored covered or in closed containers. High-percentage alcohols should be tightly sealed and stored upright. • Fruit, vegetables and salad can be stored unpacked in the drawers. This is recommended: - in high room temperatures (approx. 33°C or higher), - if the air humidity is high (e. g. during the summer). With the fan function switched on, a uniform temperature distribution will be attained in the refrigerator compartment. Cooling with fan Only original LED lamps from the appliance manufacturer may be used. The lamp can be purchased from the customer service department or specialist dealers. To switch on Press the fan button - the LED in the button will come on. WARNING! [. . . ] Subsequently, apply the enclosed stainless-steel care product evenly onto the surfaces in the same direction in which they have been ground or polished. • Only clean the door surfaces with a clean and soft cloth. If necessary, moisten the cloth (water + detergent). - Do not use abrasive sponges or scourers, do not use concentrated cleaning agents and never use cleaning agents containing sand, chloride or acid or chemical solvents, as these would damage the surfaces and could cause corrosion. [. . . ]