User manual LIEBHERR CUPSL 325 COMFORT

[. . . ] 19 Fan switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Audible warning signal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Additional functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Equipment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Connect the appliance to the mains - the appliance is switched on. · To switch the appliance off: Keep the ON / OFF button pressed for 3 sec. so that the temperature display goes out. · To switch the appliance on: Press the ON / OFF button until the Display lights up. Setting the temperature To reduce the temperature: Press the DOWN button; To increase the temperature: Press the UP button. - While you are entering the temperature, the set temperature will flash on the display. - You can change the settings in increments of 1°C briefly pressing the button again. - The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature will be displayed. If F1 appears in the display, the appliance has a fault. Consult your nearest customer service point. 19 Fan switch Thereby a climate which corresponds to that of a wine cellar is achieved inside the wine cooler. Corks are prevented from drying out due to an increased level of humidity. To switch on: Press the Ventilation button. The quality of the air is therefore decisive for preserving the wine. An activated carbon filter has been fitted in the lower area of the rear wall of the appliance to ensure that the air throughput remains at an optimum quality. We recommend that you replace the filter once a year. Filters can be obtained from your dealer. Changing the filter: Take the filter by the handle. Turn it 90° to the left or right and remove. Inserting the filter: Insert with the handle in a vertical position. Turn it 90° to the left or right until it clicks into place. 22 Storage diagrams for 750 ml Bordeaux bottles GB The loading pattern illustrated is only an example: the appliance can be loaded with different quantities depending on how the shelves are arranged. WK 4676 193 bottles CUPSL 325 COMFORT 168 bottles WK 2976 114 bottles 210 mm 210 mm 210 mm 150 mm 210 mm 210 mm 230 mm 270 mm 270 mm 230 mm 210 mm 210 mm 270 mm 270 mm 230 mm 23 Defrosting The appliance defrosts automatically. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Cleaning Before cleaning always switch off the appliance. Pull out the mains plug or remove/ unscrew the fuse. [. . . ] If none of the above causes apply and you cannot rectify the fault yourself, contact the nearest customer service department stating the type of appliance, index and appliance number as indicated on the type plate. The type plate is located on the left-hand inside wall. Shutting your appliance down If your appliance is to be shut down for any length of time, switch it off and disconnect the plug or remove the fuse. Clean the appliance and leave the door open in order to prevent unpleasant smells. 25 Changing over door hinges 1 2 3 Remove screw from lower hinge bracket. Lift door 1, tilt to the right 2 and remove 3. Transfer pin to the opposite side of the door. 4 5 6 Transfer upper hinge components to the opposite side. Transfer lower hinge bracket to the opposite side. Transfer handle to the opposite side. 7 8 9 Locate door on upper pin. Tilt door inwards from the left 1. Secure hinge pin with screw 2. If the door is not flush with the body of the appliance, adjust it using the slots on the hinge bracket. 26 If required, the enclosed lock can be fitted. GB 12 With the door hinges being on the left-hand side, the lock has to be adapted accordingly. 10 11 Remove screw. Insert key 1, turn 2, and remove pin 3. Remove lock. 13 14 15 Insert key 1 and turn 2. Remove door latch 1, turn over 2 and reassemble 3. Insert lock. 16 17 18 Insert pin 1, insert key 2 and turn 3. Insert screw. Screw on lock bracket. 27 Safety instructions and warnings · To prevent injury or damage to the unit, the appliance should be unpacked and set up by two people. [. . . ]