User manual LIEBHERR EG 1113 INSTALLATION

[. . . ] - Transfer the hinge pin 9 to the other side. W Remove the plastic cover bl from the door mounting and insert on the other side making sure it fits precisely. W Rotate the hinge 7 by 180° and transfer to the other side. [. . . ] Just loosen the decor frames bt at the side and push forwards. W Insert equaliser trims cm at top and/or bottom. W Place decor frames br/bu over panel and screw tight with retaining screws. W Cover screw heads with cover caps cl Equaliser trims for replacement appliances EK/EKB/EG * Depending on model and options 7 Installation instructions Installation information and dimensions W Fig. D: Align the unit with a spirit level and an angle. If necessary, level out by building up from underneath. The shelf and side walls of the unit must be at right-angles to one another. W Fit the refrigerator/freezer in stable kitchen units only. W The following ventilation gaps must be observed: - The depth of the ventilation channel at the rear of the unit must be at least 38 mm. - There must be a ventilation space of at least 200 cm2 underneath and at the top of the unit. The following principle applies: the greater the area the more economically the appliance will run. W Check installation dimensions in accordance with fig. D: appliance height (carcass) a, door height b, recess height c. (mm) a 872 1218 b 887 1233 c 874- 880 1220-1226 110 in. 2100 560570 1 mi 38 n. 557 593 54 90 2 Connecting to the mains Power supply (AC) and voltage at the operating point must comply with the details on the type plate. It is located inside the appliance on the left-hand side. W The appliance must be connected with a properly installed fused socket. [. . . ] - Align the door so that it is in alignment with the surrounding unit doors by means of the elongated slots in the lower hinge 8. W Screw plastic bracket ds with M5 screws dt onto the appliance at the handle side, fig. F, and align so it is flush with the front edge of the unit floor, fig. [. . . ]