User manual LIEBHERR EK 2310 COMFORT

[. . . ] W Important - Replace the cover plate 5!Fit handle (occlude any holes used with stoppers). W Rotate cover parts through 180° and re-attach them to the other side, 1, 2 and 3. 2 Torx R 15 1 3 Changing the compartment door* W Fig. Unscrew the hinge 1 and remove the compartment door with the hinge. [. . . ] W Rotate the door and closure by 180° and replace on the other side: Insert the compartment door at the top, put the hinge 1 in place at the bottom, screw down again and close the cover. 3 A2 Torx R 15 6 * Depending on model and options EK/EKB/EG Installation instructions For appliances with decor frames, fig. B: The front of your appliance can be colour-matched or contrasted with other components of a fitted kitchen through the attachment of a decor panel and frame. The following table shows the panel dimensions for your appliance: Appliance for Decor panel dimensions (mm) recess height height width max. thickness _______________________________________________ 874 - 880 860 585 4 1220 - 1226 1206 585 4 W Graduate thicker decor panels according to fig. br Decor frame bs Decor panel Assembly W Unscrew decor frame br. W Loosen decor frames bt/bu and slide forwards. W Slide all decor frames back and screw tight. Attach handle bq at required height (top or bottom - remove centre screw if at top). W Cover screw heads with cover caps cl Decor panel assembly GB For appliances with decor frames, fig. If the existing decor panel on the replacement appliance is too short, you can adjust the height with equaliser trims available in different heights. W The appliance must be connected with a properly installed fused socket. W The fuse of the plug has to be 10A or more, it must be situated away from the rear area of the appliance and be easily accessible. W Do not - connect to stand-alone inverters, - operate with so-called energy-saving plugs - this can damage the electronic system. - connect together with other appliances using an extension cable - danger of overheating. W When removing the mains cable from the back of the appliance, remove the cable holder to prevent vibration noise. W Route the mains cable with the aid of string 1 in such a way that the appliance can be easily connected after installation, fig. 200 cm² D 8 * Depending on model and options 7 a b EK/EKB/EG Installation instructions Fastening in kitchen unit W Fig. E1/2: All installation components are supplied. GB 3 2x 33 1x 36 1x 37 34 30 1x 32 2 x 35 R 2x R o 4 x 19 Torx 15 o 4 x 29 Torx 15 38 2x 39 1x 1x M 5 x 15 Torx R 25 1x 19 mm 5 mm W Slide appliance 3/4 of the way into the kitchen unit. F: slide equaliser trim dl into the channel and engage it in the key holes. W Stick sealing strip dn onto the side of the appliance on the handle side flush with the front: remove the protective film and stick on; shorten to recess height if necessary. [. . . ] W Stick sealing strip dn onto the side of the appliance on the handle side flush with the front: remove the protective film and stick on; shorten to recess height if necessary. W For 16 mm unit wall (568 mm recess): clip spacer do onto the hinge in the slot. W For19 mm unit wall (562 mm recess): the spacer is not needed. W Slide appliance into the recess until the lower hinge 8 abuts the end face of the unit wall, fig. [. . . ]