User manual LIEBHERR G 2433

[. . . ] · To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions. · Disconnect the appliance from the mains if any fault occurs. Pull out the plug, switch off or remove the fuse. · When disconnecting the appliance, pull on the plug, not on the cable. [. . . ] Connect the appliance with a properly earthed fused plug and socket only. Connecting to the mains SuperFrost is on Child lock is activated Alarm (symbol flashes if the temperature inside the appliance is too high) Setup mode is activated (activating the child lock and adjusting the display brightness) Demo mode is activated Adjusting the display brightness (this symbol is only activated in setup mode) Dimensions (mm) Switching on: Press the ON/OFF button so that the temperature display lights up/flashes. Switching off: Press the ON/OFF button for approx. 3 seconds so that the temperature display goes out. Switching the appliance on and off G 20 G 24 G 27 H = 1250 mm H = 1447 mm H = 1644 mm Press the Up/Down button, the next lower temperature value in the temperature display will light up. Keep pressing the Up/Down button until the desired value is displayed. Do not cover ventilation openings or grille. - Do not place the appliance in direct sunlight or near cookers, radiators and similar sources of heat. - The energy consumption depends on the installation conditions, e. g. - Keep the time the appliance is open to a minimum. - Keep all food properly packed and covered so as to avoid its frosting up on the outside. - Always allow hot food to cool to room temperature before placing in the appliance. - If there is a thick layer of frost in the appliance: defrost the appliance. Accumulated dust increases the energy consumption: - Once a year, dust the refrigeration unit together with the metal grid of the heat exchanger at the back of the appliance. Note After a certain period of operation, the interior temperature will adjust to the value which has been set. Setting the temperature Saving energy Audible warning signal It sounds when it is not cold enough in the freezer compartment. The temperature display and the symbol flash. The audible warning device is switched off by pressing the ALARM button. The temperature display will continue to flash until the cause of the alarm has been rectified. This can be caused by: · the freezer door being left open for a long time, allowing warm ambient air to enter; · a long power failure; · a fault in the appliance. In each case, make sure food has not thawed or perished. 9 In set-up mode you can set the child lock and adjust the brightness of the display. The child lock is designed to protect the appliance from being switched off accidentally. Additional functions Activating the child lock Press for 5 seconds. Display = Adjusting the display brightness Press for 5 seconds. Display = Display = Display = Display = Display = Display = Adjust to the desired brightness using the Up/Down button. Display = The child lock is activated. Deactivating the child lock Press for 5 seconds. Display = The adjusted brightness will be activated after one minute. [. . . ] Transfer cover plate to the opposite side. 11. Transfer upper hinge components to the opposite side. 2. 3. Tilt appliance slightly backwards and pull out hinge pin. Mount door on hinge pin and close. 13. 4. Remove the door. 4. [. . . ]