User manual LIEBHERR G 2433 COMFORT

[. . . ] · Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. The same applies to changing the mains power cable. · Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. [. . . ] To compensate for any unevenness, adjust the height of the feet with the open-ended spanner supplied. · Always ensure good ventilation. Do not cover ventilation openings or grille. · Do not place heat-emitting appliances, e. g. microwave oven, toaster, etc. , on top of the freezer. · Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. · Do not connect the appliance to the supply with other equipment using an extension cable - risk of overheating. Setting up Operating and control elements GB 3 4 1 2 5 1 Temperature display (display) 2 Temperature button 3 On/Off button 4 SuperFrost button 5 Audible warning on/off button Power supply (AC) and voltage at the operating point must comply with the details on the type plate, which is located on the inside left of the appliance. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. Connect the appliance with a properly earthed fused plug and socket only. Connecting to the mains SuperFrost is on Child lock is activated Alarm (symbol flashes if the temperature inside the appliance is too high) Setup mode is activated (activating the child lock and adjusting the display brightness) Demo mode is activated Adjusting the display brightness (this symbol is only activated in setup mode) Dimensions (mm) Switching on: Press the ON/OFF button so that the temperature display lights up/flashes. Switching off: Press the ON/OFF button for approx. When in this mode, the cooling circuit is switched off! Demo mode Display = The child lock is deactivated. will flash in the display. If the cursor in the temperature display is at -25°C, continue with the next point. If not, adjust to this position using the Up/Down button. The display is switched off for 1 second. The appliance is then back in normal operating mode. 10 The maximum amount of food (in kg) which can be frozen in 24 hours is shown on the type plate ("Freezing capacity"). Freezing Equipment GB The freezing chart represents the frozen food and the time it can be safely stored in months. Freezing chart · Press the SuperFrost button. · Place the fresh food in the freezer. · The automatic SuperFrost system automatically switches the fast freezing procedure off after 65 hours. - when placing frozen food in the freezer; - when freezing up to approx. 2 kg fresh food daily. By activating the SuperFrost function the temperature in the freezer compartment will drop to the lowest attainable value. Thus food can be rapidly frozen to the core and the quality is preserved. SuperFrost The individual storage times and whether or not the lower or upper value is applicable depend on the food quality, its processing prior to freezing, and the individual household's quality requirements. The lower values always apply to food with a high fat content. You should not switch on the SuperFrost function: The cold-storage accumulators provided prevent the temperature in the freezer from rising too quickly in the event of a power failure. To ensure maximum storage time in the event of a power failure, place the cold-storage accumulators in the top-most freezer drawer on top of the food. Cold-storage accumulators · Always store identical food items together. [. . . ] ­ Does the appliance cause nearby items of furniture or objects to vibrate?Please note that noises caused by the refrigerant circuit cannot be avoided. The temperature is not low enough: ­ Is the temperature setting correct (see "Setting the temperature")?­ Have excessive amounts of fresh food been placed in the appliance? [. . . ]