User manual LIEBHERR G 5216

[. . . ] Furthermore, the appliance is not suitable for operation in potentially explosive atmospheres. The appliance is suitable solely for cooling food in a domestic environment or similar. This includes use in, for example Range of appliance use · Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. The same applies to changing the mains power cable. · Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. [. . . ] - The temperature can be set at between -14°C and -28°C. To reduce the temperature: Press the DOWN button. To increase the temperature: Press the UP button. - Always ensure good ventilation. Do not cover ventilation openings or grille. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - The energy consumption depends on the installation conditions, e. g. - Keep the time the appliance is open to a minimum. - Ensure that all food is well packed and covered for storage. - First cool warm food to room temperature before storing it. - If there is a thick layer of frost in the appliance: defrost the appliance. Accumulated dust increases the energy consumption: - Once a year, dust the refrigerating unit together with the metal grille of the heat exchanger at the back of the appliance. Saving energy Temperature display The highest temperature of the frozen food is displayed in normal operating mode. If F 3 appears in the display, the appliance has a fault. Consult the customer service department indicating the fault number displayed. Power failure "frost-control" display If nA appears in the display, this means that the freezer temperature has risen too high during the last few hours or days due to a power failure. If you press the "ALARM" button whilst the display is reading nA, the highest temperature registered during the power failure will be displayed. Check the quality of the food and its suitability for consumption in case it has become too warm or even defrosted. The highest temperature will appear for appox. After that, the actual temperature in the freezer will re-appear. The display can be switched off by repeatedly pressing the "ALARM" button. 7 Freezing Fresh food should be frozen to the core as rapidly as possible. Frozen food can also be given a cold boost. This is provided by the "Superfrost" facility. The maximum amount of food wich can be frozen in 24 hours is shown on the type plate ("Freezing capacity . . . kg/24 hours"). This amount varies according to the model and climate rating. Notes on freezing and storage Freezing with Superfrost · For small amounts of frozen food, it is normally sufficient to switch on Superfrost 6 hours beforehand. For the maximum amount (see freezing capacity on the type plate) you will need to switch it on 24 hours beforehand. · Then place the fresh food inside the freezer. - The Superfrost function switches off automatically. [. . . ] · The temperature is not low enough: ­ Is the temperature setting correct (see "Setting the temperature")?­ Have excessive amounts of fresh food been placed in the appliance?­ Does the separately installed thermometer show the correct reading?­ Is the ventilation system working properly? [. . . ]