User manual LIEBHERR GN 2723

[. . . ] Freezer Operating instructions 091110 7085052 - 00 GN . . . 3 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 5. 10 5. 11 5. 12 5. 13 5. 14 6 6. 1 6. 2 6. 3 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Description of appliance and equipment. . . . . . . . . . . . . . . . . . Range of appliance use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] - The ventilation space under the ceiling has to be at least 300 cm2. - The larger the ventilation space, the more energy-saving the appliance is in operation. If the appliance is installed with the hinges next to a wall Fig. 8 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open. u Snap the safety lock (1) onto the turn hinge again. u If necessary, align the door to the appliance housing by way of the two oblong holes in the turn hinge Fig. To do so, unscrew the middle screw. WARNING Risk of injury due to the door dropping out!If the bearing parts are not screwed into place firmly enough, the door may drop out. What is more, the door may not close and therefore the appliance may fail to cool properly. u Screw on the bearing brackets/bearing pins tightly (4 Nm). u Check all of the screws and retighten if necessary. 4. 5 Disposing of packaging WARNING Danger of suffocation due to packing material and plastic film!u Do not allow children to play with packing material. 4. 4 Insertion into a row of kitchen units - The packaging is made of recyclable materials: corrugated board/cardboard expanded polystyrene parts polythene bags and sheets polypropylene straps nailed wooden frame with polyethylene panel* u Take the packaging material to an official collecting point. 4. 6 Connecting the appliance NOTICE Risk of damage to the electronic control system!u Do not use stand-alone inverters (conversion of d. c. to a. c. / three-phase) or energy saving plugs. WARNING Fire and overheating hazard!u Do not use extension cables or multiple socket outlets. The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). Connect the appliance only with a properly installed socket outlet with earthing contact. The socket outlet must be fused with 10 A or higher. It must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency. u Plug in the power plug. (1) Stack cabinet (2) Appliance (3) Kitchen cabinet (4) Wall Fig. 8 4. 7 Switching on the appliance u Press the On/Off button Fig. The temperature display and Alarm symbol Fig. [. . . ] u The compressor runs for longer in order to rapidly cool the food. Speed-controlled* compressors may produce varying running noise due to different speed steps. u The sound is normal. 8 Decommissioning 8. 1 Switching off the appliance u Press On/Off button Fig. w The temperature display is dark. 8. 2 Taking the appliance out of service u Empty the appliance. [. . . ]