User manual LIEBHERR GN 3076

[. . . ] Freezer Operating instructions 081110 7082660 - 01 GN . . . 6 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 4. 8 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 5. 10 5. 11 5. 12 5. 13 5. 14 5. 15 6 6. 1 6. 2 6. 3 6. 4 6. 5 7 8 8. 1 8. 2 8. 3 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Description of appliance and equipment. . . . . . . . . . . . . . . . . . Range of appliance use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 8 (1) can be fitted above the appliance. When inserting the appliance into a row of kitchen units (max. depth 580 mm), the appliance can be installed directly next to the kitchen unit Fig. The appliance door projects relative to the front of the kitchen unit by 34 mm at the side and by 50 mm in the middle of the appliance. It can be opened and closed perfectly as a result. Important for the ventilation: - At the back of the stack cabinet there has to be a ventilation duct of at least 50 mm depth throughout the width of the stack cabinet. - The ventilation space under the ceiling has to be at least 300 cm2. - The larger the ventilation space, the more energy-saving the appliance is in operation. If the appliance is installed with the hinges next to a wall Fig. 8 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open. Fig. 8 Put the appliance into operation about 2 hours before first loading food to be frozen. Do not load food to be frozen before the temperature display reads -18 °C. w The temperature display and the alarm symbol flash until the temperature is sufficiently low. If the temperature is above 0 °C, dashes flash. If it is below, the current temperature flashes. w The interior light is on when the door is open. 5 Control 5. 1 Brightness of the temperature display You can adjust the brightness of the temperature display to the light conditions of the room in which the appliance is installed. 5. 1. 1 Adjusting the brightness The brightness is adjustable between h0 (no illumination) and h5 (maximum luminosity). u To activate the setting mode: press the SuperFrost button Fig. u To confirm: briefly press the SuperFrost button Fig. u To make the display brighter: press Up button u To make the display darker: press Down button u To confirm: press SuperFrost button Fig. w The brightness is adjusted to the new value. u To deactivate the set-up mode: press On/Off button 4. 6 Disposing of packaging WARNING Danger of suffocation due to packing material and plastic film! [. . . ] u To cancel the display of the warmest temperature: press alarm button Fig. (see Maintenance). 8. 2 Switching off the appliance u Press On/Off button Fig. w The temperature display is dark. 8. 3 Taking the appliance out of service u Empty the appliance. u Put the IceMaker in the cleaning position (see Maintenance). [. . . ]