User manual LIEBHERR GN 4113

[. . . ] Freezer Operating instructions 170111 7084524 - 00 GN . . . 3 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 5. 10 5. 11 6 6. 1 6. 2 6. 3 6. 4 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Description of appliance and equipment. . . . . . . . . . . . . . . . . . Range of appliance use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 6 (11) and transfer to the opposite side. u When fitting the pressure plates, pay attention that they engage properly. u Attach the door to the bearing pin Fig. u Slightly tip the appliance backwards again and reinsert the bearing pin Fig. The notch on the bearing pin must face forward. 7 5 Control CAUTION Risk of injury if the door tips!u The safety lock (1) has to engage with the turn hinge at the side so that the bearing pin and therefore the door are secured. u If the appliance is inserted into a row of kitchen units (max. 580 mm), the appliance can be placed immediately next to the kitchen cabinet. The appliance projects 150 mm at the sides and 170 mm in the middle of the appliance, in relation to the front of the kitchen cabinet. - The ventilation space under the ceiling has to be at least 350 cm2. - The larger the ventilation space, the more energy-saving the appliance is in operation. If the appliance is installed with the hinges next to a wall Fig. 8 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open. 4. 5 Disposing of packaging u Snap the safety lock (1) onto the turn hinge again. u If necessary, align the door to the appliance housing by way of the two oblong holes in the turn hinge Fig. WARNING Danger of suffocation due to packing material and plastic film!u Do not allow children to play with packing material. The packaging is made of recyclable materials: - corrugated board/cardboard - expanded polystyrene parts - polythene bags and sheets - polypropylene straps - nailed wooden frame with polyethylene panel* u Take the packaging material to an official collecting point. WARNING Risk of injury due to the door dropping out!If the bearing parts are not screwed into place firmly enough, the door may drop out. What is more, the door may not close and therefore the appliance may fail to cool properly. u Screw on the bearing brackets/bearing pins tightly (4 Nm). [. . . ] u Have any repairs and action - not expressly specified - on the appliance and mains cable carried out by service personnel only. (see Maintenance) u Read the appliance designation Fig. 10 (3) off the type plate located inside the appliance on the lefthand side. u Notify the customer service, specifying the fault, appliance designation Fig. w This will help us to provide you with a faster and more accurate service. [. . . ]