User manual LIEBHERR GN 4113 COMFORT NOFROST

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . External dimensions of the appliance. . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Insulation plate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] u Do not place appliances emitting heat e. g. on the appliance! 3. 2 Temperature display The following are displayed in normal operation: - the set freezing temperature - the temperature setting is being changed - after switch-on the temperature is not yet cold enough - the temperature has risen several degrees The temperature display flashes: WARNING Blocked ventilation openings pose a risk of fire and damage!u Always keep the ventilation openings clear. Always ensure that the appliance is properly ventilated!u Detach the connecting cable from the rear of the appliance, removing the cable holder at the same time because otherwise there will be vibratory noise!u Remove the protective film from the decorative trims. u Dispose of packaging material (see 4. 5) . NOTICE Risk of damage due to condensate!u Do not install the appliance directly alongside a further refrigerator/freezer. u Align the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustableheight feet (A) and using a spirit level. 4 Putting into operation 4. 1 Transporting the appliance CAUTION Risk of injury and danger of damage as a result of incorrect transport!u Transport the appliance in a packed condition. to a. c. / three-phase) or energy saving plugs. WARNING Fire and overheating hazard!u Do not use extension cables or multiple socket outlets. The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). Connect the appliance only with a properly installed socket outlet with earthing contact. The socket outlet must be fused with 10 A or higher. It must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency. u Plug in the power plug. 4. 7 Switching on the appliance u Press On/Off button Fig. The temperature display and the alarm button flash until the temperature is sufficiently cold. (1) Stack cabinet (3) Kitchen cabinet (2) Appliance (4) Wall The appliance can be inserted into a row of kitchen units. 8 (2) to the height of the row of units, a suitable stack cabinet Fig. 8 (1) can be fitted above the appliance. Fig. 8 5 Control 5. 1 Door alarm If the door is open longer then 60 s, the audible alarm sounds. [. . . ] u Solution: (see Putting into operation). u The interior light automatically switches off if the door has been open for about 15 min. If the interior light is not on but the temperature display is lit, the bulb is faulty. ation circuit. A bubbling and gurgling noise. WARNING Risk of injury if repair work is not carried out professionally! [. . . ]