User manual LIEBHERR GNES 3076 PREMIUM NOFROST

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . External dimensions of the appliance. . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HomeDialog. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] u Do not place appliances emitting heat e. g. on the appliance! WARNING Blocked ventilation openings pose a risk of fire and damage!u Always keep the ventilation openings clear. Always ensure that the appliance is properly ventilated!u Detach the connecting cable from the rear of the appliance, removing the cable holder at the same time because otherwise there will be vibratory noise!u Remove the protective film from the outside of the appliance. NOTICE The stainless steel doors are provided with a high-quality surface coating and must not be treated using the accompanying care product. Otherwise the surface coating will be affected. u Wipe the coated door surfaces using a soft, clean cloth only. u Apply a stainless steel cleaner only to the stainless steel side walls evenly, wiping with the grain. Subsequent cleaning becomes easier as a result. 3 (4) goes out and the temperature display stops flashing when the temperature is sufficiently cold again. If the alarm status persists: (see Malfunction). Note Food may be spoilt if the temperature is not cold enough. Do not consume spoiled food. 5. 1. 1 Adjusting the brightness The brightness is adjustable between h0 (no illumination) and h5 (maximum luminosity). u To activate the setting mode: press the SuperFrost button Fig. u To confirm: briefly press the SuperFrost button Fig. u To make the display brighter: press Up button u To make the display darker: press Down button u To confirm: press SuperFrost button Fig. w The brightness is adjusted to the new value. u To deactivate the set-up mode: press On/Off button -oru Wait for 5 minutes. w The temperature is indicated again in the temperature display. Fig. 3 (7). 5. 4. 1 Muting the temperature alarm The audible alarm can be muted. [. . . ] The freezer temperature rose too high over the last hours or days due to a power failure or power interruption. When the power interruption is over, the appliance will continue to operate in the last temperature setting. u To cancel the display of the warmest temperature: press alarm button Fig. The outside surfaces of the appliance are warm. [. . . ]