User manual LIEBHERR GNP 2313 COMFORT NOFROST

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . External dimensions of the appliance. . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Insulation plate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 4 (1) at the bottom into the bearing pin and tighten it (with 4 Nm). u If necessary, align the door flush with the appliance housing using the two slots in the turn hinge. To do so, unscrew the middle screw. Fig. 5 (3) transfer it to the opposite location hole of the turn hinge and screw it firmly into place. 5 (4) out of the turn hinge and transfer it to the receiving hole on the opposite side of the turn hinge. 5 (6) and transfer it to the opposite side. 5 (2) firmly into place on the new hinge side (with 4 Nm), possibly using a power screwdriver. Fig. 5 WARNING Risk of injury due to the door dropping out!If the bearing parts are not screwed into place firmly enough, the door may drop out. What is more, the door may not close and therefore the appliance may fail to cool properly. u Screw on the bearing brackets/bearing pins tightly (4 Nm). If the appliance is installed with the hinges next to a wall Fig. 9 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open. 4. 7 Switching on the appliance u Press the On/Off button Fig. The temperature display and Alarm symbol Fig. 3 (10) flash until the temperature is cold enough. w If "DEMO" is displayed, demo mode is activated. Please contact the after sales service. 5 Control 5. 1 Brightness of the temperature display You can adjust the brightness of the temperature display to the light conditions of the room in which the appliance is installed. 5. 1. 1 Adjusting the brightness The backlight can either be switched off or set to one of 5 levels. u To activate the setting mode: Press the SuperFrost button Fig. 3 (9) shines and the child lock symbol Fig. 3 (6) to select the brightness function. 3 (8) goes out and the brightness symbol Fig. [. . . ] The door of the appliance is not properly closed. The appliance was opened too frequently or for too long. Wait until the appliance reaches the required temperature itself. → Too much fresh food was placed inside without SuperFrost. [. . . ]