User manual LIEBHERR GT 6122 COMFORT

[. . . ] Your old appliance: This contains some reusable materials and should be disposed of properly - not simply with unsorted household refuse. · Discarded appliances should be disabled: Remove the plug, cut through the connection cable and render the catch unusable so that children cannot become trapped inside. · Ensure that the refrigerant circuit is not damaged when the appliance that is no longer needed is taken away for disposal. · Details of the refrigerant can be found on the type plate. [. . . ] If you need space for large bottles and containers, then simply push half of glass shelf back. For cleaning the holder can be used to remove the half glass shelves. WFridge section: The temperature depends on the following factors: - The frequency of opening the door - The room temperature of the installation location - The type, temperature and quantity of the frozen food Recommended temperature setting: 5 °C. The temperature can be changed progressively. When the setting 2 °C is reached, it begins again at 9 °C. - Press the temperature setting button 2 repeatedly until the desired temperature appears in the temperature display 3. Note: By pressing the Up/Down button for a long time activates the nominal value adjustment. The set value blinks during the adjustment. - If you press it again briefly, the set value changes in 1° increments; if you hold it down it will change continuously. 5 seconds after the last button was pressed, the electronics switch over automatically and the actual temperature is shown. WFreezer section: The recommended temperature setting of 5°C in the cooling section will produce an average temperature of approx. In set-up mode you can set the child-proof lock and adjust the brightness of the display*: Activating set-up mode: W Press SuperFrost button for approx. The corresponding symbol appears in the display. Refrigerating with fan W Press SuperFrost button 5 briefly, so that the LED lights up. The corresponding symbol appears in the display. W With a smaller amount of food to be frozen, wait/pre-freeze for approx 6 hours - normally sufficient, with the maximum quantity, see freezing capacity on rating plate, approx. The water that forms on the rear wall drains into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. The defrost water is then evaporated by the compressor heat. Ensure that the water can flow without hindrance through the hole above the vegetable bins (see "Cleaning"). 6 to 10 months 6 to 12 months 6 to 12 months 6 to 12 months Freezer compartment · Switch the appliance off to defrost. Press the ON/OFF button so that the temperature display goes out. · Wrap the frozen food in paper or blankets and store in a cool place. · To speed up the defrosting process put a saucepan of hot but not boiling water on one of the cooling elements. · Leave the door of the appliance open while defrosting. After defrosting mop up the remaining water and clean the appliance. [. . . ] 2 (14) through 180° and screw it firmly into place on the new hinge side (with 4 Nm). 2 (12) through 180° and snap it into place again on the new handle side. Transferring the lower bearing elements For appliances without height adjustment - Lift out the bearing pin Fig. 3 (28), transfer it to the opposite location hole of the turn hinge and screw it firmly into place. [. . . ]