User manual LIEBHERR ICS 3314 COMFORT

[. . . ] W You can remove all door racks for cleaning, fig. W The shelves* can be adjusted according to height of frozen food, fig. - Lift the shelf, slide forwards and remove. - Always insert shelves with the raised edge at the back pointing upwards, otherwise food may freeze onto the rear wall. [. . . ] W In the event of a fault, disconnect the appliance from the mains: disconnect mains plug (do not pull on the connection cable) or trigger or unscrew fuse. W Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. The same applies to changing the mains power cable. Technical safety W When setting up/fitting ensure that the refrigerant circuit pipes are not damaged. W Once in position, use a 10 spanner to adjust the feet so that the appliance is level and does not wobble. W Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. W Always position the appliance directly up against the wall. W The ventilation grilles should not be obstructed. Observe the appendix to the installation and modification instructions. W Condensation may form on the outside of the refrigerator/freezer during periods of high humidity. Constant ventilation of the installation site is recommend. W Connect the appliance with a properly earthed fused plug and socket only. W The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. W Do not connect the appliance to the supply with other equipment using a distribution outlet - risk of overheating. W When removing the mains cable from the back of the appliance, remove the cable holder as well so as to avoid vibration noise. Connecting to the mains * according to Model and design 3 Putting into operation 4 Refrigerator compartment The interior light switches off automatically when door is open for more than approx. If the lamp does not light up when the door is opened briefly, but the temperature setting display does, the light bulb may be defective. Replacing the bulb: W Light-bulb specifications: max. 25 W, power supply and voltage should match the details on the rating plate. Only use light bulbs with the same dimensions, fitting: E 14. Disconnect mains plug or trip or unscrew fuse. Youareadvisedtocleantheappliancebeforeswitchingiton W Push the sides 1 of the lamp cover together according to Fig. forthefirsttime(see"Cleaning"). W Replace the light bulb according to Fig. [. . . ] is flashing, please contact your nearest after-sales Iftheapplianceistobe left switched off for any length of service point (see list attached). time, emptytheappliance, disconnectfromthemains, clean Please state the Appliance name 1, asdescribedaboveandleavethedooropensoastoavoid Service 2, odours. Appliance number 3 of the rating plate with (see Fig. ), and which LED indicators are flashing. The rating plate is located inside the appliance on the left-hand side. Customer service and type plate 12 * according to Model and design 7 Instructions for installation and modification Youcanchangeoverthedoorhingesifnecessary: Makesurethatthefollowingtoolsareathand: -Torx25 -Torx15 -Screwdriver -Suppliedopen-endedwrench Changing over door hinges Fig. 1 -RemovethelowercoverFig. 1(1)forwards. [. . . ]