User manual LIEBHERR IKP 2254

[. . . ] For models with soft stop 3* proceed according to fig. For appliances 870 mm high: remove the lower storage rack for easier installation. A: Detach the soft stop mechanism: Please note the soft stop mechanism contracts in the detached state!W Take hold of cover 1 at the back for removal, bend it downwards a little and push it away to the side. [. . . ] W Check installation dimensions in accordance with fig. B: Appliance height a, recess height b Installation information Power supply (AC) and voltage at the operating point must comply with the details on the type plate. It is located inside the appliance on the left-hand side. W The appliance must be connected with a properly installed fused socket. W The fuse of the plug has to be 10 A or more, it must be situated away from the rear area of the appliance and be easily accessible. W Do not - connect to stand-alone inverters, - operate with so-called energy-saving plugs - this can damage the electronic system. - connect together with other appliances using an extension cable - danger of overheating. W When removing the mains cable from the back of the appliance, remove the cable holder to prevent vibration noise. Connecting to the mains IK/IKP/IKB/IG * Depending on model and options 5 Installation instructions Figs. C1-3:All installation components are supplied. D: Fit equaliser trim bm centered on the appliance: slide into the channel and engage in the key holes. W Route the mains cable with the aid of string 1 in such a way that the appliance can be easily connected after installation. W Slide the appliance three-quarters of the way into the recess. W Note the thickness of the unit walls: For 16 mm unit wall (568 mm recess): - Fig. D: Stick sealing strip bp onto the side of the appliance on the handle side flush with the front: remove the protective film and stick on; shorten to recess height if necessary. - Clip spacers boand bq onto the hinges. E: Slide appliance into the recess until the spacers make contact with the side of the units, Fig. For 19 mm unit wall = 562 mm recess: - Fig. E2: Slide the appliance into the recess until the fronts of the hinges are flush with the sides of the unit walls; note the additional space needed for units with door furniture (knobs, sealing lips, etc. ). Allow the hinges to protrude by the additional distance required. Press the appliance on the hinge side against the wall of the unit. Installation and fitting W Fig. J: Suspend the unit door on the door of the appliance/ adjusting pins do. [. . . ] H: with at least 6 screws if the doors are made of wood board, - with 4 screws round the edge in the case of panel doors. - Lift the fitting aids dl out to the top, turn round and insert into the adjacent openings. W Fig. M: Fit all the covers: - Place the top cover cl in position and click into place. - Place lateral cover cm in position, slide it to the limit, then press on the cover until it audibly engages. [. . . ]