User manual LIEBHERR IKP 2354 PREMIUM

[. . . ] W Undo screw 2, while pressing the fork of the soft stop mechanism downwards so that it cannot suddenly disengage. W Carefully disengage the fork of the soft stop mechanism from the hinge - the mechanism contracts!W Unscrew the ball stud 4 together with the soft stop mechanism from the door and set it aside. A1, lift off cover parts 5, 6and 7 in a forward direction using a flat-blade screwdriver. [. . . ] W Fig. A2: At the hinge 1 fold away the cover. Unscrew the hinge 1 and remove the compartment door with the hinge. W Rotate the door and closure by 180° and replace on the other side: Insert the compartment door at the top, put the hinge 1 in place at the bottom, screw down again and close the cover. Changing the compartment door GB Changing over door hinges W This appliance can also be used to replace an existing appliance. In this case, remove the hinges on the unit door and in the recess. They are no longer needed as the unit door is fitted to the appliance door. B: Align the unit with a spirit level and an angle. If necessary, level out by building up from underneath. The shelf and side walls of the unit must be at right-angles to one another. W Fit the refrigerator/freezer in stable kitchen units only. W The following ventilation gaps must be observed: - The depth of the ventilation channel at the rear of the unit must be at least 38 mm. - There must be a ventilation space of at least 200 cm2 underneath and at the top of the unit. J1: Check the gap between the door and the surrounding unit doors. J2: Align the unit door flush with the surrounding unit fronts: align laterally (X) by sliding in the corresponding direction, adjust height (Y) and lateral tilt with the adjusting pins do using a screwdriver. K: Secure the mounting bracket cr to the pre-drilled holes in the appliance door using the hexagonal screw cs. W Screw the appliance door onto the unit door with the attachment brackets cr: - Ensure that both metal edges are flush (symbol //). Drill attachment holes (making a hole with a bradawl) and screw tight. W Fig. E3: Level the appliance by adjusting the adjustable feet with the spanner provided cn. Align the body of the appliance parallel to the front edges of the side walls of the unit. W Adjust the depth of the unit door (Z): - Fig. K: bottom: loosen the hexagonal screws cs with the ring spanner co provided and adjust the door. 2 mm between the unit door and the body of the unit. Do not allow knobs and sealing lips to make contact with the appliance as this can have a detrimental effect on its function. W Screw plastic bracket br onto the handle side of the appliance with M5 screws bs. - Make sure the front of the plastic bracket br is flush with the front edge of the floor of the unit. [. . . ] L3: Fix the appliance in the round hole at the bottom with the second screw bu through the plastic bracket. Fitting the unit door W Fig. G: Slide the fitting aids dl up level with the unit door, underside of stop edge of fitting aid = upper edge of unit door W Fit the attachment strut dm on the unit door: - For this purpose, unscrew the strut by way of the counternuts dn fig. G - Fig. H: Suspend the strut with the fitting aids dl on the inside of the unit door and align centrally (draw a short line in the middle of the unit door, align the arrow on the strut with it keeping the same distance to outer edges on left and right). W Fasten the attachment strut dm in the centre: - Fig. [. . . ]