User manual LIEBHERR IKS 2450

[. . . ] Otherwise continue from "Installation information", Fig B. W Fig. A1 Lift off cover parts 1, 2 in a forward direction. W Unscrew hinge 4 and screw it on again at the opposite side using the same screws. [. . . ] It is located inside the appliance on the left-hand side. W Theappliancemustbeconnectedwithaproperlyinstalledfusedsocket. W The fuse of the plug has to be 10 A or more, it must be situated away from the rear area of the appliance and be easily accessible. W Do not - connect to stand-alone inverters, - operate with so-called energy-saving plugs - this can damage the electronic system. - connect together with other appliances using an extension cable - danger of overheating. W When removing the mains cable from the back of the appliance, remove the cable holder to prevent vibration noise. 4 Changing over door hinges Changing the compartment door Installation information and dimensions Connecting to the mains * Depending on model and options IKS Installation instructions Fastening in kitchen unit W Fig. C: All installation components are supplied. GB W Slide appliance 3/4 of the way into the kitchen unit W Fig. D: Fit equaliser trim bl so as to be flush with the side wall of the appliance on the handle side: slide it into the channel and engage it in the key holes W Remove cover 1, Fig. W Screw on fastening bracket bm with screws bo. W Slide the appliance into the recess, leaving a gap of approx. 4 mm on the handle side. Pay attention to the mains cable!W Align the appliance depthwise: the unit floor and side wall. W Align the appliance heightwise: using the adjusting screws co Fig. [. . . ] Note distance d to the outeredgeoftheunitdoor, d=thicknessofunit wall. - Adjust the door connecting element so that the unit door does not make contact with the unit wall on the handle side (gap of approx. - If the unit door is large or divided into separate parts, attach another door connector if necessary! [. . . ]