User manual LIEBHERR KP 4220

[. . . ] Upright refrigerator Operating instructions 231110 7084676 - 01 K /KP/ SKes/ SKesf . . . 3 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 6 6. 1 6. 2 6. 3 6. 4 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Description of appliance and equipment. . . . . . . . . . . . . . . . . . Range of appliance use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] u Slide the spring clamp into place on the new hinge side until it clicks into place. 4. 4 Insertion into a row of kitchen units Fig. 7 (33) out of the door bearing bush and transfer it. 7 (34) and transfer to the opposite side. u When fitting the pressure plates on the opposite side, make sure they snap properly into place. * Fig. 7 4. 3. 4 Fitting the door u Place the door from above onto the lower bearing pin u Close the door. 4 (12) in the door on the new hinge side. 4 (12)firmly into place (with 4 Nm)(2x Torx® 25) Fig. Possibly make preliminary holes with a bradawl or use a cordless screwdriver. 4 (11) into place at the opposite side. Fig. 5 (22). (1) Stack cabinet (3) Kitchen cabinet (2) Appliance (4) Wall When inserting the appliance into a row of kitchen units (max. depth 580 mm), the appliance can be installed directly next to the kitchen unit Fig. The appliance door projects relative to the front of the kitchen unit by 34 mm at the side and by 50 mm in the middle of the appliance. It can be opened and closed perfectly as a result. Important for the ventilation: - At the back of the stack cabinet there has to be a ventilation duct of at least 50 mm depth throughout the width of the stack cabinet. - The ventilation space under the ceiling has to be at least 300 cm2. The larger the ventilation space, the more energy-saving the appliance is in operation. If the appliance is installed with the hinges next to a wall Fig. 8 (4), the distance between appliance and wall has to be at least 40 mm. This corresponds to the projection of the handle when the door is open. Fig. 8 4. 3. 5 Aligning the door u Align the door to the appliance housing by way of the two oblong holes in the bottom turn hinge Fig. To do so, unscrew the middle screw. WARNING Risk of injury due to the door dropping out!If the bearing parts are not screwed into place firmly enough, the door may drop out. [. . . ] u Pull out the power plug or switch off the fuse. 12 (1) at the front and unhook it at the back. 12 (1) back in place. The compressor switches to a low speed when little cold is The compressor runs for a long time. Fig. 12 This noise comes from the refrigerant flowing in the refrigeru The sound is normal. ation circuit. A bubbling and gurgling noise. 9 Decommissioning A quiet clicking noise. [. . . ]