User manual LIEBHERR KX 1021

[. . . ] When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated. · Do not stand on the plinth, drawers or doors or use them to support anything else. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] · The ventilation grilles should not be obstructed. · Condensation may form on the outside of the refrigerator/ freezer during periods of high humidity. Constant ventilation of the installation site is recommend. · Do not place heat-emitting appliances, e. g. microwave oven, toaster, etc. , on top of the freezer. · Keep burning candles, lamps and other items with naked flames away from the appliance so that they do not set the appliance on fire. · Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. If live parts or the mains lead become damp this may cause short circuits. - The appliance is designed for use in enclosed areas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions. Risk of injury and danger of damage as a result of incorrect transport!- Transport the appliance in a packed condition. - Do not transport the appliance without assistance. ·Theappliancemaybemovedonlywhenitisempty. Dimensions [mm] h 630 a 554 g 610 e 624 e' 653 d 1129 c 562 c' 591 Switching the appliance on and off You are recommended to clean the appliance before switching it on for the first time (see "Cleaning"). · Turn the temperature control 1 clockwise from "0" to "1". The appliance is now switched on. Setting the temperature Turn the temperature control perature. 1 to set the desired tem- Connecting to the mains Power supply (a. c. ) and voltage at the operating point must comply with the details on the type plate which is located on the left-hand inside wall, next to the top freezer drawer. The socket must be fused with a 10 A fuse or higher. The socket should be easily accessible and not directly behind the appliance. · Do not connect the appliance to the supply with other equipment using a distribution outlet - risk of overheating. · Connect the appliance through a properly earthed plug and socket. Setting "1" = lowest cooling setting, highest temperature Setting "7" = highest cooling setting, lowest temperature Remember that the temperature depends on the ambient temperature (location of appliance), the number of times the door is opened and how much frozen food is stored. The setting should be adjusted accordingly if necessary. Interior light Saving energy Bulb data: 15 W (never use a bulb rated at more than 15 W). [. . . ] Do not use steam cleaners because of the risk of injury and damage. · Ensure that no cleaning water penetrates into the electrical components or ventilation grille. · Dry all parts well with a cloth. · Do not damage or remove the type plate on the inside of the appliance. [. . . ]