User manual LIEBHERR TPESF 1714 COMFORT

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . External dimensions of the appliance. . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General safety information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] u Apply a stainless steel cleaner only to the stainless steel side walls evenly, wiping with the grain. Subsequent cleaning becomes easier as a result. u Wipe side walls with a paint finish using a soft, clean cloth only. u Remove the protective film from the decorative trims. * u Remove all transit supports. u Dispose of packaging material (see 4. 5) . 3. 2 Temperature display The following are displayed in normal operation: - the set cooling temperature 4 Putting into operation 4. 1 Transporting the appliance CAUTION Risk of injury and danger of damage as a result of incorrect transport!u Transport the appliance in a packed condition. u Do not transport the appliance without assistance. 4. 2 Installing the appliance In the event that the appliance is damaged, contact the supplier immediately before connecting to the mains. The floor at the site must be flat and level. 4 Putting into operation NOTICE Risk of damage due to condensate!If your appliance is not a Side-by-Side (SBS) appliance: u do not install the appliance directly alongside a further refrigerator/freezer. u Align the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustableheight feet (A) and using a spirit level. u Then support the door: Extend the adjustable foot at the turn hinge (B) until it rests on the floor and then make a further 90° turn. When a Side-by-Side appliance (S. . . ) is fitted together with a second appliance (as a SBS combination): u Proceed according to the Side-by-Side combined fridgefreezer installation instructions. u Check all of the screws and retighten if necessary. 4. 5 Disposing of packaging WARNING Danger of suffocation due to packing material and plastic film!u Do not allow children to play with packing material. 6 The packaging is made of recyclable materials: corrugated board/cardboard expanded polystyrene parts polythene bags and sheets polypropylene straps nailed wooden frame with polyethylene panel* u Take the packaging material to an official collecting point. Control 4. 6 Connecting the appliance NOTICE Risk of damage to the electronic control system!u Do not use stand-alone inverters (conversion of d. c. to a. c. / three-phase) or energy saving plugs. w The LED of the current temperature flashes in the temperature display. 3 (2) the number of times needed until the required temperature shines in the LED display. Note u Long pressing of the setting button sets a slightly colder value within a small temperature range (e. g. : between 5 °C and 7 °C). The LED of the next lower temperature range then shines in the temperature display. WARNING Fire and overheating hazard!u Do not use extension cables or multiple socket outlets. The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). Connect the appliance only with a properly installed socket outlet with earthing contact. [. . . ] u The sound is normal. After cleaning: u Wipe dry the appliance and items of equipment. u Connect the appliance and switch it on again. u Put the food back inside. 6. 3 Changing the interior light with bulb Bulb data max. 25 W Fitting: E14 Type of current and voltage must conform with the details on the type plate u Switch off the appliance. [. . . ]