User manual LIEBHERR TX 1021

[. . . ] Table-height refrigerator with freezer compartment Operating instructions 211211 7081874 - 02 TX 1021 . . . 1 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 2 3 3. 1 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 5 5. 1 5. 2 6 6. 1 6. 2 6. 3 6. 4 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Description of appliance and equipment. . . . . . . . . . . . . . . . . . Range of appliance use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 3 4 Putting into operation 4. 1 Transporting the appliance CAUTION Risk of injury and danger of damage as a result of incorrect transport!u Transport the appliance in a packed condition. u Do not transport the appliance without assistance. 4. 2 Installing the appliance WARNING Fire hazard due to dampness!If live parts or the mains lead become damp this may cause short circuits. u The appliance is designed for use in enclosed areas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions. to direct radiation of the sun, next to a cooker, heater and similar. q Always stand the appliance backed directly to the wall using the enclosed wall spacers (see below). q The appliance may be moved only when it is empty. q Do not install the appliance without assistance. q Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m2 per 8 g of R 600a refrigerant used in the appliance. If the room in which the appliance is installed is too small, a flammable gas-air mixture may form in the event of a leakage in the refrigeration circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. u Detach the connecting cable from the rear of the appliance, removing the cable holder at the same time because otherwise there will be vibratory noise!u Remove the protective film from the decorative trims. u Dispose of packaging material (see 4. 4) . u Align the appliance so that it stands firmly and on a level by applying the accompanying spanner to the adjustableheight feet (A) and using a spirit level. q The floor at the site must be flat and level. q Do not install the appliance in a location where it is exposed supplier immediately before connecting to the mains. WARNING Risk of fire due to short circuit!If the mains cable/connector of the appliance or of another appliance touch the rear of the appliance, the mains cable/ connector may be damaged by the appliance vibrations, leading to a short circuit. u Stand the appliance so that it is not touched by connectors or main cables. u Do not plug the appliance or any others into sockets located near the rear of the appliance. Note u Clean the appliance (see 6. 2) . If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance. u Always see to good ventilation at the installation site. WARNING Fire hazard due to refrigerant! [. . . ] 5 (3) off the type plate located inside the appliance on the lefthand side. The appliance is not standing firmly on the floor. As a result, Vibratory noise. u Notify the customer service, specifying the fault, appliance designation Fig. w This will help us to provide you with a faster and more accurate service. u Keep the appliance closed until the customer service arrives. [. . . ]