User manual LIEBHERR WK 2926

[. . . ] Any misuse of the appliance may result in damage to or spoilage of the stored goods. Furthermore, the appliance is unsuited for use in areas exposed to an explosion hazard. Description of appliance and equipment WK 2926 WK 4126 Temperarure control Interior light switch Temperature display Interior light WK 2927 WK 4127 Grid shelves Activated carchoal filter Type plate Adjustable- height feet 8 Adjustable- height feet Safety instructions and warnings · To prevent injury or damage to the unit, the appliance should be unpacked and set up by two people. · In the event that the appliance is damaged on delivery, contact the supplier immediately before connecting to the mains. · To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions. [. . . ] · Always ensure that there is good ventilation and that the outward flowing air is able to escape. · Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. · Do not connect the appliance to the supply with other equipment using an extension cable - risk of overheating. Dimensions WK 2926 - A=1250 mm WK 2927 - A=1264 mm WK 4126 - A=1644 mm WK 4127 - A=1658 mm Connecting to the mains Power supply (a. c. ) and voltage at the operating point must comply with the details on the type plate. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. Connect the appliance with a properly earthed fused plug and socket only. - Always ensure good ventilation. Do not cover ventilation openings or grille. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - The energy consumption depends on the installation conditions, e. g. - Keep the time the appliance is open to a minimum. Saving energy Accumulated dust increases the energy consumption: - Once a year, dust the refrigerating unit together with the metal grille of the heat exchanger at the back of the appliance. 9 Switching the appliance on and off To switch the appliance on: Connect the appliance to the mains - the appliance is switched on. To switch the appliance off: Pull out the mains plug or set the temperature control to 0. You are recommended to clean the appliance before switching it on for the first time (see Cleaning). Air exchange with activated charcoal filter The way in which wines continue to mature depends on the ambient conditions. The quality of the air is therefore decisive for preserving the wine. Setting the temperature We recommend that you replace the filter once a year. Filters can be obtained from your dealer. Changing the filter: Take the filter by the handle. Turn it 90° to the left or right and remove. Inserting the filter: Insert with the handle in a vertical position. Turn it 90° to the left or right until it clicks into place. Using a coin, turn the arrow on the temperature control to a setting between 0 und max. The nearer the temperature control is to the max. setting, the colder the interior temperature. If you are storing wine for long periods of time, it should be stored at a temperature of between 10°C and 14°C. Storing wine This is the temperature wine cellars are kept at, and it is just right to allow wine to mature properly. The following drinking temperatures are recommended for the various types of wine. [. . . ] ­ Is the ventilation system working properly?­ Is the appliance set up too close to a heat source?If none of the above causes apply and you cannot rectify the fault yourself, contact the nearest customer service department stating the type of appliance 1, service number 2and appliance number 3as indicated on the type plate. [. . . ]