User manual LIEBHERR WKES 653

[. . . ] Operating instructions Wine storage cabinet Page 16 7081 295-00 508 Many thanks for your trust. Congratulations on your purchase of this wine storage cabinet. In buying this product, which is distinguished by its perfect user-friendliness, impeccable reliability and high quality, you have chosen a top class appliance. We wish you a lot of pleasure with your new wine storage cabinet - and a lot of enjoyment from your wines. The fewer the grapes produced in an area, the better the wine. Poor, well-drained soils are best for good wines. The properties of the soil influence the vitality of the vine, which in turn affects the quality of the grape. [. . . ] - The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature will be displayed. The temperature can be set between +5°C and +20°C. Fan switch Thereby a climate which corresponds to that of a wine cellar is achieved inside the appliance. Corks are prevented from drying out due to an increased level of humidity. Switching on: Press the Ventilation button. Switching off: Press the Ventilation button again. The symbol will go out. 20 Audible warning signal It sounds when the door has been left open for longer than 60 seconds. It sounds when the interior gets too warm or too cold. The temperature display will also flash. The audible warning device is switched off by pressing the Alarm button. GB The audible warning signal helps to protect your wines against excessive temperatures fluctuations. The temperature display will continue to flash until the cause of the alarm has been rectified. Interior light The interior light is fitted on the inside at the top. The interior lighti can be switched on and off using the Light button. The symbol lights up when the light is switched on. When cover is removed, do not look directly at light through optical instruments. The interior lighting may only be replaced by the customer service technician or by competent skilled personnel!Furthermore, the brightness of the lighting can be adjusted. Press and hold the Light button and at the same time press the temperature setting buttons to increase or decrease the brightness. Down = darker Up = brighter 21 Setup mode The following functions can be activated in setup mode: = Child lock = Display brightness = Child lock The child lock is designed to protect the appliance from being switched off accidentally. Activating the child lock · Activate setup mode by pressing the - The display reads · Press the button. button for 5 seconds. - The display reads · Press the - The button again. symbol will light up to indicate that the child lock is activated. button for 5 seconds. · Exit setup mode by pressing the Deactivating the child lock · Activate setup mode by pressing the - The display reads · Press the button. - The display reads · Press the - The button again. symbol will go out, indicating that the child lock is deactivated. button. · Exit setup mode by pressing the 22 = Display brightness Adjusting the display brightness · Activate setup mode by pressing the · Press the Press the button until button. [. . . ] · Loud running noise: - Check that the appliance is standing firmly on the ground. Please note that it is impossible to avoid flowing noises in the refrigerant circuit. The same applies to changing the mains power cable. · Do not stand on the plinth, drawers or doors or use them to support anything else. [. . . ]