User manual LIEBHERR WT 4677

[. . . ] · To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions. · Disconnect the appliance from the mains if any fault occurs. Pull out the plug, switch off or remove the fuse. · When disconnecting the appliance, pull on the plug, not on the cable. [. . . ] · Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. · Do not connect the appliance to the supply with other equipment using an extension cable - risk of overheating. To switch the appliance on: Press the ON/OFF button until the temperature display lights up. You are recommended to clean the appliance before switching it on for the first time (see Cleaning). Switching the appliance on and off GB To switch the appliance off: Keep the ON/OFF button pressed for approx. 3 seconds so that the temperature display goes out. Note: The two control systems can be switched on and off separately. Connecting to the mains The temperature of all compartments can be set separately. Setting the temperature Power supply (a. c. ) and voltage at the operating point must comply with the details on the type plate. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. 1 Upper compartment 2 Middle compartment 3 Lower compartment Connect the appliance with a properly earthed fused plug and socket only. To reduce the temperature: Press the DOWN button. Operating and control elements for upper and middle compartment - While you are entering the temperature, the set temperature will flash on the display. - You can change the settings in increments of 1°C briefly pressing the button again. - The electronic control system will switch over automatically about 5 seconds after the last time you pressed the button, and the actual temperature will be displayed. The following drinking temperatures are recommended for the various types of wine. Red wines: +14°C to +18°C Rosé wines: +10°C to +12°C White wines: +8°C to +12°C Sparkling wines, Prosecco +7°C to +9°C Champagne +5°C to +7°C To increase the temperature: Press the UP button. 1Upper compartment temperature display 2Upper compartment temperature setting buttons 3Middle compartment temperature display 4Middle compartment temperature setting buttons 5Audible warning on/off button 6Interior light on/off button 7Child-proof lock 8On/off button 9Fan button for lower compartment If F0 or F1 appears in the display, the appliance has a fault. Consult your nearest customer service point. Operating and control elements - It sounds when the door has been left open for longer than about 60 seconds. - It sounds when the interior gets too warm or too cold. The temperature display will also flash. The audible warning device is switched off by pressing the ALARM button. The audible warning signal helps to protect your wines against excessive temperature fluctuations. Audible warning signal bl Temperature display bm Temperature setting buttons bn Audible warning on/off button bo Fan button bp Child-proof lock bq button On/off - Always ensure good ventilation. Do not cover ventilation openings or grille. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - The energy consumption depends on the installation conditions, e. g. - Keep the time the appliance is open to a minimum. Saving energy Accumulated dust increases the energy consumption: - Once a year, dust the refrigerating unit together with the metal grille of the heat exchanger at the back of the appliance. 9 Should you wish to use the wine cooler to store wine for long periods of time, activate the "Ventilation" button. Thereby a climate which corresponds to that of a wine cellar is achieved inside the wine cooler. Corks are prevented from drying out due to an increased level of humidity. Fan button Labels The appliance is supplied with a label holder with labels for each shelf. Use these to label the type of wine stored on each shelf. Additional labels can be obtained from your dealer. Fitting: Click the label holder into place and slide the label in from the side. Activating set-up mode: · Press Ventilation button for approx. - The display shows c for child-proof lock. [. . . ] Pull out the mains plug or remove/unscrew the fuse. · Clean the inside, equipment and outer walls with lukewarm water and a little detergent. Do not use abrasive or acid cleaners or chemical solvents. Do not use steam cleaners because of the risk of injury and damage. · Ensure that no cleaning water penetrates into the electrical components or ventilation grille. [. . . ]