User manual LIEBHERR WTI 2050

[. . . ] Multi-temperature wine cabinet for integrated use, door-on-door Operating and installation instructions 251010 7084026 - 01 WTI . . . 6 Appliance at a glance Contents 1 1. 1 1. 2 1. 3 1. 4 1. 5 2 3 3. 1 3. 2 4 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 5 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 5. 8 5. 9 6 6. 1 6. 2 6. 3 7 8 8. 1 8. 2 9 Appliance at a glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Description of appliance and equipment. . . . . . . . . . . . . . . . . . Range of appliance use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 17 In case of units with (16 mm and 19 mm) door stop components (knobs, sealing lips etc. ): u To allow for the extra distance (depth of door stop components): allow the hinges to protrude by the extra distance. Fig. (Distance between appliance door and lower edge of crosspiece) Fig. 22 7 Putting into operation u Push up assembly aids Fig. Lower edge of the assembly aid = top edge of the unit door to be fitted. 23 (12) by undoing the locknuts u Attach the fastening crosspiece Fig. 23 (11) to the inside of the unit door. Fig. 22 (14). u Centre the fastening crosspiece Fig. 23 (12): mark a short centre line on the unit door and put the tip of the arrow on the crosspiece above it. w Distances to the outer edge are equal at the left and right. For chipboard doors: u secure fastening crosspiece Fig. For frame and panel doors: u secure fastening crosspiece Fig. 23 (11) for removal, turn them and insert them into the adjacent openings. Fig. 23 u To align the unit door in depth Z: undo screws Fig. 26 (19) at the door, then move the door. 2 mm between the unit door and the body of the unit. Do not allow knobs and sealing lips to contact the door - important for function!For large or sectioned unit doors: u fit a 2nd pair of mounting brackets u Use the holes pre-drilled in the handle area of the appliance door for this purpose. Fig. 25 (18). u Attach the unit door to the adjusting bolts Fig. 24 (17) and loosely screw the locknuts Fig. u Check the gap between the door and the surrounding unit doors. u To laterally align the unit door: move the unit door in the X direction. u To align the unit door in height Y and in lateral inclination: adjust the adjusting bolt Fig. [. . . ] Note u Do not clean wooden grid shelves with water and washingup liquid. The compressor switches to a low speed when little cold is The compressor runs for a long time. 11 Decommissioning This noise comes from the refrigerant flowing in the refrigeru The sound is normal. A quiet clicking noise. The noise is produced whenever the refrigeration unit (motor) automatically switches on or off. It is briefly a little louder when the refrigeration unit (the motor) switches on. The refrigeration increases automatically when fresh food has just been placed in the appliance or the door has been left open for a while. [. . . ]