User manual LIEBHERR WTI 2050 VINIDOR

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . External dimensions of the appliance. . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General safety information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For 16 mm thick unit walls = 568 mm wide recess: u Let the spacers abut the side wall of the unit. Fig. 14 Note Incorrect installation will lead to malfunction!If the distance is not kept, the door may not close. This may lead to icing, to condensate forming and to malfunction. u Be sure to keep to a spacing of 42 mm all the way round. (Allow for door stop components, such as knobs and sealing lips. ) Fasten the appliance in the recess with screws: u by screwing long Spax screws Fig. 20 (10) through the top and bottom hinge plates. Fig. 15 For 19 mm thick unit walls = 562 mm wide recess: u Align the front edges of the hinges so as to be flush with the side wall of the unit. Fig. 16 u Pre-assemble by passing a long screw Fig. 21 (8)through the centre of the oblong hole in the plastic bracket Fig. u Fold down the cover of the plastic bracket Fig. w The unit door is flush and in alignment with the surrounding unit fronts. 25 (19) into the pilot holes in the appliance door. Fig. 24 u Check the fit of the door and readjust if necessary. 27 (21) while holding the adjusting bolts Fig. 27 (1) from below using three screws Fig. u Fix the appliance in the round hole at the bottom with the second screw Fig. 27 (8) through the plastic bracket u Snap covers into place. Fig. 25 Ensure that both metal edges are flush (symbol //): u Drill pilot holes in the door of the unit (possibly make preliminary hole with a bradawl). u Screw the appliance door to the unit door with screws Fig. 25 (15) passed through the mounting brackets Fig. 25 (18). 8 Control top cover Fig. [. . . ] u Remove the caps and screws of the metal cover (1) and side them aside. u Raise the metal cover (2) and draw it forwards (3). u To clean the drain opening: remove any deposits with a fine instrument, e. g. Items of equipment: u Wipe wooden grid shelves with a dry, lint-free cloth. [. . . ]