User manual LIEBHERR ZKES 453

[. . . ] Operating instructions Cigar storage unit Page 18 7081 293-00 309 Many thanks for your trust. Congratulations on your purchase of this cigar storage unit. In buying this product, which is distinguished by its perfect user-friendliness, impeccable reliability and high quality, you have chosen a top class appliance. We hope that you enjoy your new cigar storage unit - and that you get a lot of pleasure from your exclusive cigars. Optimum humidity and temperature are key. The very best humidors keep cigars at an even and constant relative humidity. Experts put the ideal level at 68-75% at an interior temperature of between 16 and 20°C. [. . . ] The temperature can be set between +16°C and +20°C. 22 Adjusting the humidity To reduce the humidity: Press the Down button. To increase the humidity: Press the Up button. GB - While you are setting the humidity, the display will flash. - About 5 seconds after the button was last pressed, the actual interior humidity will be displayed. The humidity can be adjusted between 68% and 75%. Lighting The light is integrated into the door frame and can be switched on and off by pressing the Light button. The LED lights up when the light is operational. The brightness of the light can also be adjusted. · Press and hold the Light button and at the same time press the humidity setting buttons to increase or decrease the brightness. Down = darker, Up = brighter. 23 Audible warning signal The audible warning signal sounds in the event of a malfunction. It will always sound when the door has been left open for longer than 60 seconds. It will also sound if the interior becomes too cold or too warm or if the humidity is too high or too low. The corresponding display will also flash. The Stop the signal by pressing the Alarm button. LED will light up. Control elements LED lights up when the lighting is operational. LED lights up when the child lock is active. LED flashes when the temperature or humidity inside the appliance is too high or too low. LED lights up when the water tank needs topping up. This alarm will activate when the water level drops to 400 ml (sufficient to allow the appliance to run properly for another 6 weeks). When topping up the water, always remove any impurities such as cigar leaves. If the water tank is very dirty, clean it and refill with fresh water. 24 Setup mode The following functions can be activated in setup mode: = Child lock = Display brightness GB = Child lock The child lock is designed to protect the appliance from being switched off accidentally. Activating the child lock · Activate setup mode by pressing the - The display reads · Press the button. button for 5 seconds. - The display reads · Press the - The button again. symbol will light up to indicate that the child lock is activated. button. · Exit setup mode by pressing the Deactivating the child lock · Activate setup mode by pressing th - The display reads · Press the button. button for 5 seconds. - The display reads · Press the - The button again. symbol will go out, indicating that the child lock is deactivated. [. . . ] · Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. The same applies to changing the mains power cable. · Do not stand on the plinth, drawers or doors or use them to support anything else. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ]