User manual LIFESCAN ONETOUCH BASIC

[. . . ] ® TM Blood Glucose Monitoring System OWNER'S BOOKLET a company Dear ONE TOUCH® BASICTM Owner: Congratulations!You've chosen a very easyto-use blood glucose monitoring system for home testing. Your ONE TOUCH BASIC System will give you the accurate test results you need, in just a few simple steps. Everything you need to know about using the ONE TOUCH BASIC System is included in this booklet. [. . . ] If you run out of space in your Logbook, you can get a new one from your Authorized LifeScan Distributor, drug store, or directly from LifeScan. 37 Displaying Last Test Result The ONE TOUCH® BASICTM Meter automatically recalls and displays your last result--either from a blood glucose or Control Solution test--whenever the Meter is turned on. memory 106 (example) or memory c98 (example) Only blood glucose or Control Solution test results are recalled and displayed. Check Strip test results are not stored in the Meter memory. When using the Meter for the first time memory no data appears to indicate that there is no blood glucose or Control Solution test result in the Meter's memory. appears for 3 seconds, then the Meter immediately displays test messages starting with code 7 (example) 38 7. (Troubleshooting) The display messages that appear on the Meter will guide you through the glucose test and quality control test procedures and alert you to problems as they occur. This section provides you with a complete listing of the display messages, what they mean, and what to do if there is a problem. 39 Test Procedure Messages These messages appear during routine testing. Just follow them carefully and they will guide you through the test. MESSAGE APPEARS WHEN You press and hold the On/Off Button. It provides a visual test that all display segments are working. memory 108 (example) The Meter is turned on. The value displayed is your last blood glucose test result. (When using the Meter for the first time, memory nodata will appear. ) The Meter is turned on. The value displayed is your last Control Solution test result. (example) memory code 7 The Meter is in a code setting mode. The code number (1­16) displayed must match the code number on the Test Strip package. 40 MESSAGE APPEARS WHEN insert strip wait apply sample The Meter is ready for you to perform a blood, Check Strip, or Control Solution test. The Meter is performing internal checks. The Meter is ready to receive a blood or Control Solution sample. If performing a Check Strip test, this is your signal to remove the Check Strip (Side 1) from the Meter. The Meter is counting down from 45 seconds to 0. 108 (example) A blood test is completed. This indicates a blood glucose result. 41 MESSAGE APPEARS WHEN c 90 (example) contrl A Control Solution test is completed. However, if this appears after a blood test, it means that your test result was not accurate because the blood sample was too small and the Meter read it as a Control Solution sample. Turn the Check Strip over and slide it back into the Test Strip Holder with Side 2 up. The Check Strip result falls into the acceptable range. insert side 2 A80 Aok (example) high Your blood glucose result is above 600 mg/dL. Contact your physician immediately. 42 p1 You are setting the Display Language. [. . . ] SPECIFICATIONS Performance Characteristics See the ONE TOUCH® Test Strip package insert for ONE TOUCH® System accuracy and precision. Power Supply: One Duracell® alkaline battery, size J (6V) part # 7K67 is included with Meter. Battery Life: Approximately one year (at two tests per day). Display Type: Alphanumeric; 6-character, 14-segment LCD. 71 Dimensions: Length --4 3/4 Width--2 5/8 Height -- 1 1/16 Weight --approx. [. . . ]